Code: E3-2
Display: E3-2:REG JAM
Description: There is a paper jam at the Regi position.
The Sensor Photo:Regi turns ON immediately after the power is turned ON or when the Cover Assy Front is close.
The Sensor Photo:Regi turns ON immediately after the power is turned ON or when the Cover Assy Front is close.
Remedy: 1 INITIAL ANALYSIS Inspect the following components. • Sensor Photo:Regi • Actuator Regi • PWBA Conn • PWBA HKB26 MCU • PWBA HKB PS • Gear Assy Drive Are they compatible with your printer version, correctly installed, not damaged, deformed, or contaminated? Go to step 2. Replace the problem components. 2 Is the paper that is loaded in the paper tray wrinkled or damaged? Replace with fresh, dry paper. Go to step 3. 3 Is there a sheet of paper at the Actuator Regi when the E3 code appears? Remove the jammed paper. Go to step 4. 4 SENSOR PHOTO REGI ANALYSIS 1. Use SENSOR/ SWITCH CHECK to check the Sensor Photo: Regi. 2. Use a sheet of paper to actuate the sensor. Does the Sensor Regi function correctly and increment the Sensor Check number on the screen each time you actuate it? Go to step 5. Replace the Sensor Photo: Regi . 5 HARNESS ASSY REGI (J43-J431, J432) ANALYSIS 1. Disconnect the Harness Assy Regi (J43-J431, J432) from the PWBA Conn . 2. Check the continuity between J43-3 <=> J432-3, J43-4 <=> J432-2 and J43-5 <=> J432-1. Is there the continuity between J43-3 <=> J423-3, J43-4 <=> J432-2 and J43-5 <=> J432-1? Go to step 6. Replace the Harness Assy Regi (J43- J431, J432). 6 PWBA CONN ANALYSIS 1. Disconnect the Harness Assy Conn (J23-J231) from the PWBA HKB26 MCU . 2. Check the continuity between P231-7 <=> P41-3, P231-6 <=> P41-5 and P231-10 <=> P43-4. Is there the continuity between J231-7 <=> J41-3, J231-6 <=> J41-5 and J231-10 <=> J43-4? Replace the PWBA HKB26 MCU . Replace the PWBA Conn .