Code: E4
Display: E4-2:EXITJAM
Description: There is a paper jam for the standard cut paper at the Sensor Exit.
1. The Sensor Photo:Exit does not turn OFF within the specified time after the Sensor Photo: Exit turning ON.
2. The Sensor Photo:Exit turns ON immediately after the power is turned on or when the CoverAssy Front is close.
1. The Sensor Photo:Exit does not turn OFF within the specified time after the Sensor Photo: Exit turning ON.
2. The Sensor Photo:Exit turns ON immediately after the power is turned on or when the CoverAssy Front is close.
Remedy: 1 INITIAL ANALYSIS Inspect the following components. • PWBA HKB26 MCU • Cassette Assy • Switch Size on the PWBA Feeder • Fuser Assy • PWBA LVPS • Motor Assy Exit • Actuator Full Stack • Sensor Photo:Exit • Feeder Assy • Option Feeder Assy • Sensor Photo: Face Control Paper • Motor Assy Are they compatible with your printer version, correctly installed, not damaged, deformed, or contaminated? Go to step 2. Replace the problem components. 2 Does the error code appear immediately after you switch ON Main Power? Go to step 3. Go to step 4. 3 Is there paper jammed at the Sensor Exit in the Fuser Assy ? Remove the paper. Go to step 7. 4 DECURL ROLL of the FUSER ASSY ANALYSIS Check the rotation of Decurl Roll using MAIN MOTOR TEST. Inspect the Decurl Roll operation. Does the Decurl Roll rotate smoothly? Go to step 5. Replace the Fuser Assy . 5 DECURL ROLL of the FUSER ASSY ANALYSIS Open the Cover Rear and cheat the interlock switch. Generate a test print to check the Decurl Roll. Does the paper pass through the Decurl Roll without problems? Go to step 6. Replace the Fuser Assy . 6 SENSOR EXIT of the FUSER ASSY ANALYSIS 1. Check the Sensor Exit of the Fuser Assy using SENSOR/ SWITCH CHECK. 2. Manually feed a sheet of paper into the Fuser Assy, then remove the sheet of paper. Does the Exit Actuator move freely and without binding and does the Sensor Exit function correctly and increment the Sensor Check number on the screen each time you actuate the Sensor? Go to step 7. Replace the Fuser Assy . 7 ACTUATOR CST ANALYSIS Remove the Cassette Assy . Inspect the combination of the Actuator CST. Does the combination of the Actuator CST show the correct combination for the paper size present in the cassette? Go to 6.12 Paper Size Sensor Failure. Replace the Cassette Assy. 8 ROLL ASSY MID 1, MID 2 and MID3 ANALYSIS Check the operation of the Roll Assies MID. Does the Roll Assies MID function normally? Go to step 10. Go to step 9. 9 MOTOR ASSY EXIT ANALYSIS Check the voltage between P/J32-1 and frame ground. Is there +24VDC between P/J32-1 and frame ground? Replace the Motor Assy Exit . Replace the PWBA HKB26 MCU . 10 ACTUATOR FULL STACK ANALYSIS Fill the Exit Tray with paper. Does the paper lift the Actuator Full Stack, and does the Actuator expose the photo-sensing point of the Sensor Photo:Exit ? Go to step 11. Replace the Actuator Full Stack or replace the Sensor Photo:Exit . 11 SWITCH ASSY I/L REAR ANALYSIS Use SENSOR/ SWITCH CHECK to check the function of the Switch Assy I/L Rear. Open and close the Cover Rear . Does the Switch Assy I/L Rear function correctly and increment the Sensor Check number on the screen each time you actuate it? Replace the PWBA HKB26 MCU . Replace the Cover Rear .