Code: E4-3
Display: E4-3:EXIT JAM
Description: There is a paper jam at the Sensor Exit. The paper of Universal or Custom does not actuate the Sensor Photo:Exit within the specified time from the Sensor Photo Regi OFF timing.
Remedy: 1 INITIAL ANALYSIS Inspect the following components. • PWBA HKB26 MCU • P/H Assy • Switch Size on the PWBA Feeder • Fuser Assy • PWBA LVPS • Motor Assy Exit • Actuator Full Stack • Sensor Photo:Exit Are they compatible with your printer version, correctly installed, not damaged, deformed, or contaminated? Go to step 2. Replace the problem components. 2 Does the error code appear immediately after you switch ON Main Power? Go to step 3. Go to step 4. 3 Is there paper jammed at the Sensor Exit in the Fuser Assy ? Remove the paper. Go to step 7. 4 DECURL ROLL of the FUSER ASSY ANALYSIS Check the rotation of Decurl Roll using MAIN MOTOR TEST. Remove the CRU and inspect the Decurl Roll operation. Does the Decurl Roll rotate smoothly? Go to step 5. Replace the Fuser Assy . 5 DECURL ROLL of the FUSER ASSY ANALYSIS Open the Cover Rear and cheat the interlock switch. Generate a test print to check the Decurl Roll. Does the paper pass through the Decurl Roll without problems? Go to step 6. Replace the Fuser Assy . 6 SENSOR EXIT in the FUSER ASSY ANALYSIS 1. Check the Sensor Exit in the Fuser Assy using SENSOR/ SWITCH CHECH. 2. Manually feed a sheet of paper into the Fuser Assy, then remove the sheet of paper. Does the Exit Actuator move freely and without binding and does the Sensor Exit function correctly and increment the Sensor Check number on the screen each time you actuate the Sensor? Go to step 7. Replace the Fuser Assy . 7 ROLL ASSY MID 1, MID 2 and MID3 ANALYSIS Check the operation of the Roll Assis MID. Does the Roll Assis MID function normally? Go to step 9. Go to step 8. 8 MOTOR ASSY EXIT ANALYSIS Check the voltage between P/J32-1 and frame ground. Is there +24VDC between P/J32-1 and frame ground? Replace the Motor Assy Exit . Replace the PWBA HKB26 MCU . 9 ACTUATOR FULL STACK ANALYSIS Fill the Exit Tray with paper. Does the paper lift the Actuator Full Stack, and does the Actuator expose the photo-sensing point of the Sensor Photo:Exit ? Go to step 10. Replace the Actuator Full Stack or replace the Sensor Photo:Exit . 10 SWITCH ASSY I/L REAR ANALYSIS 1. Use SENSOR/ SWITCH CHECK to check the function of the Switch Assy I/L Rear. 2. Open and close the Cover Rear . Does the Switch Assy I/L Rear function correctly and increment the Sensor Check number on the screen each time you actuate it? Replace the PWBA HKB26 MCU . Replace the Cover Rear .