Code: U6
Display: U6:NVM FAIL
Description: There is a problem with NVRAM.
1. An NVRAM read error occurred immediately when you switched ON main power.
2. A write error occurred when you tried to write toNVRAM.
3. The overflow of the Task Table.
1. An NVRAM read error occurred immediately when you switched ON main power.
2. A write error occurred when you tried to write toNVRAM.
3. The overflow of the Task Table.
Remedy: 1 INITIAL ANALYSIS Inspect the following component. • PWBA HKB26 MCU Is it compatible with your printer version, correctly installed, not damaged, deformed, or contaminated? Go to step 2. Replace the problem component. 2 Does U6 appear after you switch ON Main Power? Go to step 5. Problem corrected. 3 Switch Main Power OFF and ON several times. Does U6 still appear when you switch ON Main Power again? Go to step 4. Problem solved. 4 PWBA HKB26 MCU ANALYSIS Enter DIAGNOSTIC MODE MENU. Can you enter DIAGNOSTIC MODE MENU? Go to step 5. Replace the PWBA HKB26 MCU . (If U6 continues, go to 6.20 Electrical Noise). 5 NVRAM ANALYSIS Enter ADJUSTMENT MODE MENU and check the parameters for each value of NVRAM Code. Are all parameters set correctly? Replace the PWBA HKB26 MCU . Go to step 6. 6 PWBA HKB26 MCU ANALYSIS 1. Enter correct parameters. 2. Switch OFF Main Power. 3. Switch ON Main Power. Does U6 still appear? Replace the PWBA HKB26 MCU . Problem solved. Return to Service Flowchart.