Code: 442
Description: Intermediate transfer contact Sensor error (01: Home position error, 02: Contact error, 03: Non-contact error)
- Home position error: SC442-01 If the home position is not set within the T4 time after turning ON the feed motor and feed clutch, an error results. - Contact error: SC442-02 If the contact state is not set within the T3 time after turning ON the feed motor and feed clutch, an error results. - Non-contact error: SC442-03 If the non-contact state is not set within the T3 time after turning ON the feed motor and feed clutch, an error results. [Error time T3] SP value: 100 to 25500 ms Initial value: 3000 ms Note: Contact/non-contact error judgment [Error time T4] SP value: 100 to 25500 ms Initial value: 3000 ms Note: Home position error judgment.
- Home position error: SC442-01 If the home position is not set within the T4 time after turning ON the feed motor and feed clutch, an error results. - Contact error: SC442-02 If the contact state is not set within the T3 time after turning ON the feed motor and feed clutch, an error results. - Non-contact error: SC442-03 If the non-contact state is not set within the T3 time after turning ON the feed motor and feed clutch, an error results. [Error time T3] SP value: 100 to 25500 ms Initial value: 3000 ms Note: Contact/non-contact error judgment [Error time T4] SP value: 100 to 25500 ms Initial value: 3000 ms Note: Home position error judgment.
Causes: • High motor load • Failed motor • Disconnected connector • Broken harness wire • PSU: +24 V fuse blown • Failed interlock mechanism • Failed Engine Board
Remedy: 1. Connect and disconnect the Image Transfer Unit 2. Replace the Image Transfer Unit 3. Replace the Engine Board 4. Replace the ITB (Image Transfer Belt) Contact Clutch 5. Replace the Paper Feed Motor