Code: 220-02
Description: Laser synchronizing detection error: start position [C]: LD1
The laser synchronizing detection signal for the start position of the LDB [K], [C], [M], [Y] is not output for 600 ms after LDB unit turned on while the polygon motor is rotating normally.
The laser synchronizing detection signal for the start position of the LDB [K], [C], [M], [Y] is not output for 600 ms after LDB unit turned on while the polygon motor is rotating normally.
Causes: Disconnected or defective I/F harness to laser synchronizing detection unit. Defective laser synchronizing detection unit. The laser fails to reach the photo detector. Defective GAVD. Defective LD board or driver. Defective BCU.
Remedy: • Turn the main power switch off and on. • Replace the laser optics housing unit. • Replace the I/F harness. • Replace the BCU.