Code: 921
Description: Fuser Error Indicates that the fuser is below proper temperature during standby or idle time.
Remedy: Fuser AC cables LVPS/HVPS Fuser If the fuser lamp comes on and a fuser failure light error code displays, be sure the thermistor is contacting the hot roll and the thermistor cable is firmly seated in connector J15 on the controller card. Check for excessive toner buildup on the surface of the thermistor. Clean as necessary. With the MFP unplugged, disconnect the thermistor cable from J15 on the controller card. Measure the resistance of the thermistor. The resistance measures from approximately 1K ohms immediately after printing or POR to approximately 240K ohms when thermistor reaches room temperature. (It may take 30 minutes to cool.) Replace the fuser assembly as necessary.