Description: POST Error Fuser motor not connected.
Remedy: 1 1. Turn the printer off. 2. Remove the rear frame cover. See “Rear frame cover removal”. 3. Reseat the cables in connectors JCARTP1 and JCARTS1. Did the error clear? Problem resolved. Go to step 2. 2 Check the cartridge motor 1/fuser cable in connector JCARTP1 and JCARTS1 for pinch points and the cable or connector for any other damage. Is the cable damaged? Replace the cartridge motor1/fuser cable. See “Cartridge motor 1/fuser cable removal”. Go to step 4. 3 1. Remove the right cover. See “Right cover removal”. 2. Check the cartridge motor 1/fuser motor cable for proper connection to the EP drive assembly, pinch point for the cable, and damage to the cable or connector Is either cable damaged? Replace the cartridge motor1/fuser motor cable. See “Cartridge motor 1/ fuser cable removal”. Go to step 4. 4 1. Disconnect the cable connecting motor 1/ fuser motor cable and cartridge motor 2/ motor 3, and connect the cable to the new EP drive assembly outside the machine. 2. POR the printer, then check if the error remains. Did the error clear? Replace the EP drive assembly. See “Electrophotographic (EP) drive assembly removal”. Go to step 5. 5 Connect a new cartridge motor1/fuser motor cable to the old EP drive assembly without installing it into the machine. Did the error clear? Replace the cartridge motor1/fuser motor cable. See “Cartridge motor 1/ fuser cable removal”. Replace the system board. See “System board removal”.