• Code: 1198
• Description: Door Open Jam 1
• Causes: Top Sensor/ Media Width Sensor/ Fixing Delivery Sensor/ Duplex Reverse Sensor PS204/PS205/ PS915/ PS201
• Remedy:

• Code: 11D8
• Description: Door Open Jam 1
• Causes: Top Sensor/ Media Width Sensor/ Fixing Delivery Sensor/ Duplex Reverse Sensor PS204/PS205/ PS915/ PS201
• Remedy:

• Code: E000-0000
• Description: Error in temperature rising of Fixing Assembly
• Causes: Temperature of the Fixing Assembly did not reach a certain temperature within the specified period of time.
• Remedy: 1. Check the connector connection between the Fixing Assembly and the Engine Controller PCB. 2. Replace the Fixing Assembly. 3. Replace the Engine Controller PCB.

• Code: E001-0000
• Description: Abnormal high temperature of Fixing Assembly
• Causes: It was detected that the temperature of the Fixing Assembly was abnormally high.
• Remedy: 1. Check the connector connection between the Fixing Assembly and the Engine Controller PCB. 2. Replace the Fixing Assembly. 3. Replace the Engine Controller PCB.

• Code: E003-0000
• Description: Abnormal low temperature of Fixing Assembly
• Causes: It was detected that the temperature of the Fixing Assembly was abnormally low.
• Remedy: 1. Check the connector connection between the Fixing Assembly and the Engine Controller PCB. 2. Replace the Fixing Assembly. 3. Replace the Engine Controller PCB.

• Code: E004-0000
• Description: Error in fixing power supply drive circuit
• Causes: The zero cross signal was not detected for the specified period of time or more.
• Remedy: 1. Check the connector connection between the Fixing Assembly and the Engine Controller PCB. 2. Replace the Fixing Assembly. 3. Replace the Engine Controller PCB.

• Code: E014-0000
• Description: Error in startup of the Main Motor
• Causes: Revolution of the Main Motor did not reach the specified value.
• Remedy: 1. Check the connector connection between the Main Motor and the Engine Controller PCB. 2. Replace the Main Motor. 3. Replace the Engine Controller PCB.

• Code: E100-0000
• Description: Laser Scanner Assembly error
• Causes: BD cycle of the Laser Scanner Unit was not within the specified range.
• Remedy: 1. Check the connector connection between the Main Controller PCB and the Laser Scanner Unit. 2. Check the connector connection between the Relay PCB and the Laser Scanner Unit. 3. Replace the Laser Scanner Unit.