Description: Fixing temperature control startup error
Causes: Temperature of the Fixing Assembly did not reach the specified temperature within the specified period of time.
Remedy: When the same error repeatedly occurs although the power is turned OFF and then ON for several times, execute the following remedy. 1. Check connectors on the fixing unit. 2. Replace the fixing unit. 3. Replace the engine controller PCB.
Description: Abnormal high temperature of Fixing Assembly
Causes: The detected temperature of the thermistor is 220 deg C or higher 30 times consecutively
Remedy: When the same error repeatedly occurs although the power is turned OFF and then ON for several times, execute the following remedy. 1. Check connectors on the fixing unit. 2. Replace the fixing unit. 3. Replace the engine controller PCB.
Description: Abnormal low temperature of Fixing Assembly
Causes: After the heater is turned on, the detected temperature of the thermistor is 100 deg C or lower at the time of printing after reaching 50 deg C. • After the heater is turned on, the detected temperature of the thermistor is 55 deg C or lower at paper intervals or in cleaning mode after reaching 50 deg C.
Remedy: When the same error repeatedly occurs although the power is turned OFF and then ON for several times, execute the following remedy. 1. Check connectors on the fixing unit. 2. Replace the fixing unit. 3. Replace the engine controller PCB.
Causes: An abnormal frequency is detected on the fixing drive circuit within approx. 3.3 sec of the power being turned on.
Remedy: When the same error repeatedly occurs although the power is turned OFF and then ON for several times, execute the following remedy. 1. Check connectors on the fixing unit. 2. Replace the fixing unit. 3. Replace the engine controller PCB.
Causes: Error in the Scanner Motor, Laser Unit, or BD detection in the scanner area
Remedy: When the same error repeatedly occurs although the power is turned OFF and then ON for several times, execute the following remedy. 1. Replace the scanner unit. 2. Replace the engine controller PCB.
Description: Error in main controller communication
Causes: Access to the Flash ROM in the Main Controller failed.
Remedy: When the same error repeatedly occurs although the power is turned OFF and then ON for several times, execute the following remedy. 1. Replace the Main Controller PCB.
Nhận ưu đãi sớm nhất khi chương trình diễn ra
Đăng ký nhận bản tin
Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này.
Chính sách cookie
Những cookie này là cần thiết để trang web hoạt động đúng cách.
Những cookie này giúp chúng tôi hiểu cách khách truy cập tương tác với trang web.
Những cookie này được sử dụng để cung cấp quảng cáo cá nhân hóa.