Code :

Code: 1000 ... 100C
Display: Ink Level: Check Not much ink is left. Prepare to replace the ink.
Description: Ink tank near-empty (continued use allowed) The remaining volume of ink is diminishing (below the pin check level). (XX: Target color display) Last 2 digits of error code: 00:Bk, 01:Y, 02:M, 03:C, 04:PM, 05:PC, 06:MBk1, 07:MBk2, 08:GY, 09:PGY, 0A:R, 0B:B, 0C:G
Remedy: 1. Replace the tank (continued usage allowed). 2. If the problem persists after the tank has been replaced, the remaining ink detection system is at fault. (Replace the supply unit or check catching wire or connection status of harness.)

Code: 100F
Display: End of paper feed. Cannot feed paper any more.
Description: The limit of forced paper feeding. The media reached to a pinchroller at feeding backfeed media manually. (not an error or a failure)
Remedy: The message is cleared automatically after displaying for 2sec. Confirmation of Paper detection sensor/ Media sensor sensor (I/O mode)

Code: 1010
Display: Problem with Printhead L/R Chk printing results
Description: Head non-ejection warning (Check printout/ possible to continue printing) See 280C for detection criteria.
Remedy: 1. Check image quality. (Unless there are problems with the image quality, there is no need to replace the printhead.) 2. Replace the printhead.

Code: 1012
Display: Problem with Printhead R Chk printing results
Description: Printhead R non-ejection warning (doublehead model) (Check printout/ possible to continue printing) See 280C for detection criteria.
Remedy: 1. Check image quality. (Unless there are problems with the image quality, there is no need to replace the printhead.) 2. Replace the printhead.

Code: 1013
Display: Problem with Printhead L Chk printing results
Description: Printhead L non-ejection warning (doublehead model) (Check printout/ possible to continue printing) See 280C for detection criteria.
Remedy: 1. Check image quality. (Unless there are problems with the image quality, there is no need to replace the printhead.) 2. Replace the printhead.

Code: 1015
Display: This type of paper is not compatible with HP-GL/2.
Description: HP-GL2 error: out of the scope of paper support [Warning Indication] or [Pause] have been selected for [Paper Mismatch Detection]. The paper that is being fed does not support HP-GL/2 printing; that is, a paper type that does not have a required print mode has been set.
Remedy: When [Warning Indication] is selected Replace with appropriate paper. When [Pause] is selected 1. Press the [Online] button to force printing. Caution) Due to use of image process table (LUT) defined for HP-GL/2 compatible paper different from the specified paper, you might have a problem in quality of image. 2. Press the [Stop] button to cancel printing.

1 2 3 4 > Last ›