• Code: 201A
• Display: Paper not aligned with right guide. Press OK and then reload the roll paper.
• Description: When loading cut sheet, paper (right) side detection was failed.
• Remedy: The error is cleared by releasing the release lever. After that, load paper to the correct position.

• Code: 201B
• Display: Roll paper is not securely in contact with roll holder. Press OK, then re-attach the roll paper.
• Description: When loading roll paper, paper (right) side detection was failed.
• Remedy: Paper is ejected automatically, and by pressing the [OK] button the error is cleared. After that, load paper to the correct position.

• Code: 201C
• Display: Paper jam Push the release lever back.
• Description: While printing, paper width was detected to have fluctuated beyond the predefined value. Failure of detecting right edge of the paper (cut paper, in printing).
• Remedy: By releasing the release lever, move to the loading sequence, and load paper to the correct position.

• Code: 201D
• Display: Paper jam Remove the paper after cutting at the top of feed slot. Push the release lever back.
• Description: While printing, paper width was detected to have fluctuated beyond the predefined value. Failure of detecting right edge of the paper (cut paper, in printing).
• Remedy: 1. Cut the paper near the feed slot, and remove the paper. 2. Release the release lever, and load the paper to the correct position.

• Code: 201E
• Display: Media Type not compatible with cassette. Check Media Type. Stop: Stop Printing
• Description: Paper mismatch (cut sheet) Cassette pickup has been specified for paper that does not support cassette pickup.
• Remedy: Check the cassette pick-up setting/ paper type.

• Code: 2405
• Display: Borderless printng not possible. Lift the release lever and reload the paper. Online: Print
• Description: Invalid paper loading position (borderless printing) The position at which paper is loaded is unfit for borderless printing. Data with a borderless print specification has been received while the left or right edge of roll paper was off the center of the borderless print idle ejection port at the completion of roll paper pickup.
• Remedy: Reload the roll paper. Check spacers

• Code: 2406
• Display: Borderless printng not possible. Check paper size setting. Online: Print Load/Eject: Change Paper
• Description: Borderless print data not printable (logic) Borderless print data was received at the start of printing and one or more of the following requirements are met at the same time: -A feeder slot other than one for roll paper has been specified in the data. -A paper type that does not support borderless printing has been set on the data. -Banner printing has been specified on the data at the same time. -A paper size that does not support borderless printing has been specified in a job for which paper had already been fed.
• Remedy: Reset the driver and RIP.

• Code: 2407
• Display: Borderless printng not possible. Paper stretched or shrank. Confirm usage cond. of the paper.
• Description: It occurs when all of the following conditions are met at start of printing. -Borderless printing data has been received. -Roll paper has been loaded, and its paper width and edge position recognized at loading are within the supported range of borderless printing. -As a result of right/left side edge detection after start of print processing, it was detected as beyond the supported range of borderless printing.
• Remedy: Reset /replace the roll paper. Confirm and explain usage environment.