Display: Cannot calibrate. Press OK and try calibration again.
Description: Color calibration error The adjustment value has gone out of bounds during calibration.
Remedy: 1. Check to see if the loaded paper permit calibration. 2. Check calibrated printed matter for soiling and other defects. 3. Check the nozzle pattern
Display: Calibration There is a problem with the multi-sensor. Press OK to cancel calibration.
Description: Faulty multisensor (on calibration) A failure to calibrate has been detected from the parts counter.
Remedy: 1. Check the parts counter in service mode and replace the multisensor unit. 2. Initialize the counter for the replacement unit mounted. (It is recommended to estimate the usage status of other units coming to the end of their service life and replace them as needed.)
Display: Hardware error. 03130031-2F3B Turn off printer, wait, then turn on again.
Description: CS communication error An irrecoverable communication error has occurred communicating between the CS chip mounted on the ink tank and the main unit.
Remedy: 1. Remove and insert the ink tank, or replace the ink tank. 2. Check bundled wires in the ink tank unit and the main controller PCB. 3. Replace the main controller PCB.
Display: Hardware error. 03130031-2F3C Turn off printer, wait, then turn on again.
Description: LF nip sensor error. When executing nip automatic operation, one of the following conditions is met. -The sensor detected nip closed after the nip completed opening operation. -The sensor detected nip open after the nip completed closing operation.