Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Canon iR Advance 4225i — Trang 3/31

Code: E032-0001

Description: Failure of NE Controller Counter
Detection of open circuit of count pulse signal.
Remedy: Disconnection of cable.

Code: E110-0001

Description: Failure of the Polygon Motor (M11)
The Polygon Motor (M11) speed lock signal does not indicate a locked state a specific period of time after the Polygon Motor (M11) has been started. * The same condition is detected after the error retry is performed.
Remedy: 1. Check connection of the Connector (J1/J7/J10/J21/J208/ J8142/J8143). 2. Replace the Laser Scanner Unit. 3. Replace the DC Controller PCB (UN2).

Code: E110-0002

Description: Failure of the Polygon Motor (M11)
The speed lock signal indicates a deviation 10 times in sequence at intervals of 100 msec after the signal has indicated a locked state. * The same condition is detected after the error retry is performed.
Remedy: 1. Check connection of the Connector (J1/J7/J10/J21/J208/ J8142/J8143). 2. Replace the Laser Scanner Unit. 3. Replace the DC Controller PCB (UN2).

Code: E110-0003

Description: Failure of the Polygon Motor (M11)
The Polygon Motor (M11) speed lock signal does not indicate a locked state for 6.5 sec. after a switchover is made from low to normal speed or for 8 sec. after a switchover is made from normal to low speed. * The same condition is detected after the error retry is
Remedy: 1. Check connection of the Connector (J1/J7/J10/J21/J208/ J8142/J8143). 2. Replace the Laser Scanner Unit. 3. Replace the DC Controller PCB (UN2).

Code: E196-0000

Description: Error in EEPROM access
20 retries failed after error occurred during communication with EEPROM. * Error occurs after the delivery if a paper in passage exists.g
Remedy: Replace the DC Controller PCB (UN2).

Code: E196-0001

Description: Main ROM reading/writing error
The main ROM reading or writing error occurs.
Remedy: Replace the DC controller PCB (UN2).

Code: E196-0002

Description: Option ROM reading/writing error
The option ROM reading or writing error occurs.
Remedy: Replace the DC controller PCB (UN2).

Code: E197-0000

Description: Error in communication of Laser Driver PCB Communication time out error between DC Controller PCB and Main Controller PCB 2
Communication error with image PCB (For factory) Communication time out error between DC Controller PCB and Main Controller PCB 2
Remedy: 1. Check the cable. 2. Replace the Laser Scanner Unit. 3. Replace the DC Controller PCB (UN2). 4. Replace the Main Controller PCB 2 (UN14)
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie