Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Canon iR Advance C2020i — Trang 18/45

Code: E196-1B04

Description: E2PROM communication error
Command error
Remedy: Turn OFF and then ON the main power

Code: E196-1BFF

Description: E2PROM communication error
Command error
Remedy: Turn OFF and then ON the main power

Code: E197-0000

Description: HOB communication error
Remedy: High Voltage contact point error or DC Controller PCB error When this symptom occurs regularly 1-1. Replace the DC Controller PCB (UN09) When this symptom occurs incidentally 1-2. Check the high voltage contact point and clean the Primary Transfer Roller Shaft Support 2-2. Replace the DC Controller PCB (UN09)

Code: E197-0050

Description: HOB communication error
Remedy: High Voltage contact point error or DC Controller PCB error When this symptom occurs regularly 1-1. Replace the DC Controller PCB (UN09) When this symptom occurs incidentally 1-2. Check the high voltage contact point and clean the Primary Transfer Roller Shaft Support 2-2. Replace the DC Controller PCB (UN09)

Code: E202-0001

Description: There is an error in the detection of the Scanner Unit home position.
The attempt to detect the home position fails when the Scanner Unit is moved forward.
Remedy: 1.Disconnect and then connect the flexible cable(Relay PCB(PCB1)-Main Controller2 PCB(UN12)64Pin). 2.Replace the flexible cable. 3.Replace the Scanner Unit HP sensor(SR1). 4.Replace the Scanner Motor(M1). 5.Replace the Relay PCB(PCB1). 6.Replace the Main Controller2 PCB(UN12)

Code: E202-0002

Description: There is an error in the detection of the Scanner Unit home position.
The attempt to detect the home position fails when the Scanner Unit is moved back.
Remedy: 1.Disconnect and then connect the flexible cable(Relay PCB(PCB1)-Main Controller2 PCB(UN12)64Pin). 2.Replace the flexible cable. 3.Replace the Scanner Unit HP sensor(SR1). 4.Replace the Scanner Motor(M1). 5.Replace the Relay PCB(PCB1). 6.Replace the Main Controller2 PCB(UN12)

Code: E225-0001

Description: The light intensity of the Scanner Unit is faulty.
The light intensity of the Scanner Unit during shading is under the specified level.
Remedy: 1.Disconnect and then connect the flexible cable. 2.Replace the flexible cable. 3.Replace the Scanner Unit. 4.Replace the Relay PCB(PCB1). 5.Replace the Main Controller2 PCB(UN12).

Code: E227-0001

Description: The reader unit power supply (24V) is faulty.
At time of power-on, the 24V port is off.
Remedy: 1.Disconnect and then connect the power supply harness connector. 2.Replace the Power Supply PCB(UN1).
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie