• Code: E808-0002
• Description: Zero cross signal detection error
  Unable to detect 43 to 57Hz for 500 msec or longer after confirmation of a zero cross cycle
• Remedy: Electrical trouble with failed zero cross signal 1. Check failure between the AC Driver PCB (UN14/ J122) and the DC Controller PCB (UN09/ J10). (trapped cable, open circuit, connector disconnection) -> Replace the part in the case of trapped cable/open circuit 2. Replace the AC Driver PCB (UN14) 3. Replace the DC Controller PCB (UN09) 4. Check the power supply condition at the customer site. When it is below 43 to 57Hz, ask for a construction work.

• Code: E880-0001
• Description: Controller Fan error
  Lock of Controller Fan is detected
• Remedy: Check if the connector is connected If the connector is OK, replace Controller Fan (FM3)

• Code: E996-0071
• Description: Frequent error avoidance jam (ADF)
• Remedy: Depending on the setting of JM-ERR-R in service mode, “010071” jam is displayed as an error. Collect log and contact to the sales companies. To cancel the setting, select COPIER> OPTION> FNC-SW> J M-ERR-R, and set JM-ERR-R to 0.

• Code: E996-0CA1
• Description: Frequent error avoidance jam (PRINTER)
• Remedy: Make “000CA1” jam to be displayed as an error by setting M-ERR-D in service mode. Collect log and contact to the sales companies. To cancel the setting, select COPIER> OPTION> FNC-SW> J M-ERR-D, and set JM-ERR-D to 0.

• Code: E996-0CA2
• Description: Frequent error avoidance jam (PRINTER)
• Remedy: Make “000CA2” jam to be displayed as an error by setting M-ERR-D in service mode. Collect log and contact to the sales companies. To cancel the setting, select COPIER> OPTION> FNC-SW> J M-ERR-D, and set JM-ERR-D to 0.

• Code: E996-0CA3
• Description: Frequent error avoidance jam (PRINTER)
• Remedy: Make “000CA3” jam to be displayed as an error by setting M-ERR-D in service mode. Collect log and contact to the sales companies. To cancel the setting, select COPIER> OPTION> FNC-SW> J M-ERR-D, and set JM-ERR-D to 0.

• Code: E996-0CF1
• Description: Frequent error avoidance jam (PRINTER)
• Remedy: Make “000CF1” jam to be displayed as an error by setting M-ERR-D in service mode. Collect log and contact to the sales companies. To cancel the setting, select COPIER> OPTION> FNC-SW> J M-ERR-D, and set JM-ERR-D to 0.