Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Canon iR Advance C5560i — Trang 44/72

Code: 719-0032-00

Description: Error in serial communication at the start of the New Card Reader
Causes: Communication failed in the middle of the operation although communication with the serial New Card Reader was successful at start-up.
Remedy: - Check if the cable of the serial New Card Reader is disconnected.

Code: 720-0001-00

Description: Error due to non-compatible Finisher
Causes: Non-compatible Finisher was connected.
Remedy: Connect either the Staple Finisher-Y1 or Saddle Stitch Finisher-Y1.

Code: 730-C001-00

Description: Error in HDD access
Causes: An error occurred when accessing the HDD.
Remedy: [Related parts] R1.00 - Harness between the Main Controller PCB and the HDD - HDD - Main Controller PCB [Remedy] Perform the following in the order while checking whether the error is cleared. 1. Format the HDD and reinstall the system software using SST or a USB flash drive. 2. Check/replace the related harness/cable, connector and parts.

Code: 731-3000-00

Description: Main Controller PCB error
Causes: Unable to recognize the SURF Board.
Remedy: Check/replace the Main Controller PCB

Code: 731-3001-00

Description: Main Controller PCB error
Causes: Failure of SURF initialization.
Remedy: Check/replace the Main Controller PCB

Code: 731-3002-00

Description: Main Controller PCB error
Causes: Failure of SURF initialization.
Remedy: Check/replace the Main Controller PCB

Code: 731-3015-00

Description: Main Controller PCB error
Causes: Video data is not transmitted to CL1-G even though there is no problem in the software.
Remedy: Check/replace the Main Controller PCB

Code: 732-0001-00

Description: Communication error
Causes: A communication error between the Reader Controller PCB and the Main Controller PCB was detected.
Remedy: [Related parts] R1.00 - Harness between the Reader Controller PCB (UN_BO1/J109) and the Riser PCB (J7) - Reader Controller PCB (UN_BO1) - Riser PCB - Main Controller PCB [Remedy] Check/replace the related harness/cable, connector and parts. [Reference] Before replacing the Reader Controller PCB, back up the service mode data (approx. 2 min) and restore the backup data after the replacement so the data may be able to be protected. - Backup: COPIER (LEVEL2)> FUNCTION> SYSTEM> RSRAMBUP - Restoration: COPIER (LEVEL2)> FUNCTION> SYSTEM> RSRAMRES
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie