Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Canon iR Advance C7270 — Trang 62/75

Code: E719-0003

Description: Coin vendor failure. In the case of communication error with the Coin vendor during the unit price acquisition in startup
Remedy: Recover with service mode COPIER> FUNCTION> CLEAR> ERR after cable check

Code: E719-0011

Description: Error in the card reader startup. When the card reader, which should have been connected before the power off, is not connected at power ON.
Remedy: Recover with service mode COPIER> FUNCTION> CLEAR> ERR after cable check

Code: E719-0012

Description: IPC error in the card reader operation. In the case of the errors that disconnection of IPC, or IPC communication is unrecoverable.
Remedy: Recover with service mode COPIER> FUNCTION> CLEAR> ERR after cable check

Code: E719-0031

Description: Communication error in the card reader (a serial number) startup. In case a communication with card reader cannot start in startup
Remedy: 1. Recover with service mode COPIER> FUNCTION> CLEAR> ERR after cable connection check for card reader (Connector connection, pinching wire) 2. Execute the following service mode after card reader removal, and re-install card reader. • COPIER> FUNCTION> CLEAR> CARD • COPIER> FUNCTION> CLEAR> ERR

Code: E719-0032

Description: Communication error after the card reader (a serial number) startup. Communicate with card reader is succeeded in the startup, but it became impossible.
Remedy: Recover with service mode COPIER> FUNCTION> CLEAR> ERR after cable connection check for card reader (Connector connection, pinching wire)

Code: E720-0001

Description: Model mismatch error. An accessory that is not supported is connected.
Remedy: Check the configuration of accessories. Staple Finisher-K1 is connected with iR ADV C9280.

Code: E720-0002

Description: Model mismatch error. An accessory that is not supported is connected.
Remedy: Check the configuration of accessories. Staple Finisher-K1 is connected with iR ADV C9270.

Code: E720-0003

Description: Model mismatch error. An accessory that is not supported is connected.
Remedy: Check the configuration of accessories. A wrong Finisher is connected.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie