• Code: E571-0001
• Description: Gripper Open/Close Motor (M7) error
  The gripper unit does not leave the gripper unit home position when the Gripper Open/Close Motor (M7) has been driven for 0.25 seconds.
• Remedy: 1.Replace the Grip Arm Sensor (S13). 2.Replace the Gripper Open/Close Motor (M7). 3.Replace the Finisher Controller PCB (PCB1).

• Code: E571-0002
• Description: Gripper Open/Close Motor (M7) error
  The gripper unit does not return to the gripper unit home position when the Gripper Open/Close Motor (M7) has been driven for 0.15 seconds.
• Remedy: 1.Replace the Grip Arm Sensor (S13). 2.Replace the Gripper Open/Close Motor (M7). 3.Replace the Finisher Controller PCB (PCB1).

• Code: E575-0001
• Description: Gripper Unit Move Motor (M2) error
  The gripper unit does not leave the gripper unit home position when the Gripper Unit Move Motor (M2) has been driven for 3.8 seconds.
• Remedy: 1.Replace the Gripper Unit HP Sensor (S7). 2.Replace the Gripper Unit Move Motor (M2). 3.Replace the Finisher Controller PCB (PCB1).

• Code: E575-0002
• Description: Gripper Unit Move Motor (M2) error
  The gripper unit does not return to the gripper unit home position when the Gripper Unit Move Motor (M2) has been driven for 0.1 seconds.
• Remedy: 1.Replace the Gripper Unit HP Sensor (S7). 2.Replace the Gripper Unit Move Motor (M2). 3.Replace the Finisher Controller PCB (PCB1).

• Code: E602-0001
• Description: The built-in SD card is not detected
• Remedy:

• Code: E602-1105
• Description: Access to the built-in SD card failed
• Remedy:

• Code: E711-0001
• Description: Error in UFDI communication
  The communication system error (such as reception timeout or checksum error) occurred.
• Remedy: 1.Check and Replace the cable. 2.Replace the DC Controller PCB (PCB4). 3.Replace the Finisher Controller PCB.

• Code: E713-0000
• Description: Erroneous communication with finisher
  The communication does not restart by the error retry after the communication failure with the finisher.
• Remedy: 1.Check the cable. 2.Replace the DC Controller PCB (PCB4). 3.Replace the Finisher Controller PCB.