• Code: E5F8-0003
• Description: Saddle connector error
  The connector of the paper butting plate leading edge sensor has been identified as being disconnected. Connector of paper butting plate leading edge sensor (PI15S)
• Remedy: Connect the connector of the paper butting plate leading edge sensor. Check the harness. Replace the finisher controller PCB.

• Code: E5F9-0001
• Description: Saddle switch error
  The inlet cover switch has been identified as being open for 1 sec or more after the start of printing or the start of initial rotation with the following sensors identifying their respective covers as being closed: -inlet cover sensor (PI9S) -nt cover open/closed sensor (PI2S) -delivery cover sensor (PI3S) Or, the front over switch (MS2S) or the delivery cover switch (MS3S) is open. Inlet cover switch (MS1S)/front cover switch (MS2S)/delivery cover switch (MS3S)
• Remedy: Check the inlet cover switch. Check the inlet cover sensor. Check the front cover open/ closed sensor. Check the delivery cover sensor. Replace the finisher controller PCB.

• Code: E5F9-0002
• Description: Saddle switch error
  The front cover switch has been identified as being open from the start of printing or the start of initial rotation with the following sensors identifying their respective covers as being closed. -inlet cover sensor (PI9S) -front cover open/closed sensor (PI2S) -delivery cover sensor (PI3S) -front cover switch (MS2S)/delivery cover switch (MS3S)
• Remedy: Check the front cover switch. Check the inlet cover sensor. Check the front cover open/ closed sensor. Check the delivery cover sensor. Replace the finisher controller PCB.

• Code: E5F9-0003
• Description: Saddle switch error
  The delivery cover switch has been identified as being open after the start of printing or the start of initial rotation of the host machine with the following sensors identifying their respective covers as being closed: -inlet cover sensor (PI9S) -front cover open/closed sensor (PI2S) -delivery cover sensor (PI3S) - delivery cover switch (MS3S)
• Remedy: Check the delivery cover switch. Check the inlet cover sensor. Check the inlet cover sensor. Check the front cover open/closed sensor. Check the delivery cover sensor. Replace the finisher controller PCB.

• Code: E602-0001
• Description: There is an error on the hard disk.
  [Cause] An HDD detection error has occurred. The HDD cannot be detected. The HDD does not become ready. The HDD returns an error. [Detection] while boot ROM is in session BARSAC startup, mounting (usrIde) [Timing of Detection] once at startup
• Remedy:

• Code: E602-0002
• Description: There is an error on the hard disk.
  [Cause] There is no startup file. The program for the main CPU does not exist on the HDD or in BOOTDEV/BOOT, and so on. [Detection] while boot ROM is in use at time of system file loading (usrIde) [Timing of Detection] once at startup
• Remedy:

• Code: E602-0003
• Description: There is an error on the hard disk.
  [Cause] An HD write abort error has occurred. The sectors for BOOTDEV on the HD cannot be read. [Detection] BARSAC (all; at time of bootable startup) [Timing of Detection] once at startup
• Remedy:

• Code: E602-0006
• Description: There is an error on the hard disk.
  [Cause] A subbootable that matches the PDL type does not exit in BOOTDEV/BOOT. [Detection] during loading of sub boot in oclibroot [Timing of Detection] once at bootable startup
• Remedy: