• Code: E5F5-0002
• Description: Saddle front stapling error
  The stitching home position sensor does not go off when the switch motor (front) has been rotated in normal direction for 0.5 sec or more. Stitch motor (front; M7S)/stitching home position sensor (front; MS7S)
• Remedy: Replace the stitcher (front). Check the harness. Replace the finisher controller PCB.

• Code: E5F6-0001
• Description: Saddle butting error
  The paper butting plate home position sensor does not go on when the paper butting plate motor has been driven for 0.3 sec. Paper butting plate motor (M8S)/paper butting plate home position sensor (PI14S)
• Remedy: Check the paper butting plate motor. Check the paper butting plate home position sensor. Replace the finisher controller PCB.

• Code: E5F6-0002
• Description: Saddle butting error
  The paper butting plate home position sensor does not go off when the paper butting plate motor has been driven for 80 msec or more. Paper butting plate motor (M8S)/paper butting plate home position sensor (PI14S)
• Remedy: Check the paper butting plate motor. Check the paper butting plate home position sensor. Replace the finisher controller PCB.

• Code: E5F6-0003
• Description: Saddle butting error
  The number of detection pulses of the paper butting plate motor has dropped below a specific value. paper butting plate motor (M8S)/paper butting plate motor clock sensor (PI1S)
• Remedy: Check the paper butting plate motor. Check the paper butting plate motor clock sensor. Replace the finisher controller PCB.

• Code: E5F6-0004
• Description: Saddle butting error
  The paper butting plate leading edge sensor does not go off when the paper butting plate motor has been driven for 80 msec. Paper butting plate motor (M8S)/paper butting plate leading edge sensor (PI15S)
• Remedy: Check the paper butting plate motor. Check the paper butting plate leading edge sensor. Replace the finisher controller PCB.

• Code: E5F6-0005
• Description: Saddle butting error
  The paper butting plate leading edge sensor does not go on when the paper butting plate motor has been driven for 0.3 sec. Paper butting plate more (M8S)/paper butting plate leading edge sensor (PI15S)
• Remedy: Check the paper butting plate motor. Check the paper butting plate leading edge sensor. Replace the finisher controller PCB.

• Code: E5F8-0001
• Description: Saddle connector error
  The connector of the paper butting plate home position sensor has been identified as being disconnected. Connector of guide home position sensor (PI13S)
• Remedy: Connect the connector of the guide home position sensor. Check the harness. Replace the finisher controller PCB.

• Code: E5F8-0002
• Description: Saddle connector error
  The connector of the paper butting plate home position sensor has been identified as being disconnected. Connector of paper butting plate home position sensor (PI14S)
• Remedy: Connect the connector of the paper butting plate home position sensor. Check the harness. Replace the finisher controller PCB.