• Code: E716-0010
• Description: There is an error in the communication with the pedestal.
  When the communication with the 3 Way Unit-A1 is faulty after detecting the connection with the finisher.
• Remedy: Install the 3 Way Unit-A1. Replace the DC controller PCB after checking the cable

• Code: E717-0001
• Description: There is an error in the communication with the NE controller.
  The NE controller is not connected at power on, although it was connected before the power was turned off because of an error.
• Remedy: Check the cable; thereafter, reset the condition in service mode: COPIER>FUNCTION>CLEAR>ERR.

• Code: E717-0002
• Description: There is an error in the communication with the NE controller.
  An IPC error has occurred while the NE controller is in operation. There is an open circuit for the IPC. An error has occurred, and the IPC communication remains disabled.
• Remedy: Check the cable; thereafter, reset the condition in service mode: COPIER>FUNCTION>CLEAR>ERR.

• Code: E719-0001
• Description: There is a coin vendor error.
  The coin vendor is not connected when the power is turned on, although it was connected before the power was turned off because of an error.
• Remedy: Check the cable; thereafter, reset the condition in service mode: COPIER>FUNCTION>CLEAR>ERR.

• Code: E719-0002
• Description: There is a coin vendor error.
  While the coin vendor is in operation, an IPC error has occurred, IPC has developed an open circuit, or an error preventing recovery of IPC communication has occurred. An open circuit has been detected in the line for the pickup/delivery signal. An illegal signal has been detected.
• Remedy: Check the cable; thereafter, reset the condition in service mode: COPIER>FUNCTION>CLEAR>ERR.

• Code: E719-0003
• Description: There is a coin vendor error.
  While the unit price is being checked at startup, an error occurs in the communication with the coin vendor.
• Remedy: Check the cable; thereafter, reset the condition in service mode: COPIER>FUNCTION>CLEAR>ERR.

• Code: E719-0011
• Description: There is a coin vendor error.
  An error has occurred at new card reader startup. The new card reader is not connected when the power is turned off, although it was connected when the power was turned off.
• Remedy: Check the cable; thereafter, reset the condition in service mode: COPIER>FUNCTION>CLEAR>ERR.

• Code: E719-0012
• Description: There is a coin vendor error.
  An IPC error has occurred at new card reader startup. There is an IPC open circuit. An error has occurred that prevents recovery of IPC communication.
• Remedy: Check the cable; thereafter, reset the condition in service mode: COPIER>FUNCTION>CLEAR>ERR.