Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Canon iR3230 — Trang 4/30

Code: E110-0001

Description: The scanner motor is faulty.
The scanner motor speed lock signal does not indicate a locked state a specific period of time after the scanner motor has been started.
Remedy: Replace the laser unit. Replace the DC controller PCB. Check the wiring.

Code: E110-0002

Description: The scanner motor is faulty.
The speed lock signal indicates a deviation 10 times in sequence at intervals of 10 msec after the signal has indicated a locked state.
Remedy: Replace the laser unit. Replace the DC controller PCB. Check the wiring.

Code: E110-0003

Description: With the image clock switched over, the scanner motor speed lock signal does not indicate a locked state 6.5 sec after a switchover is made from low to normal speed or 8 sec after a switchover is made from normal to low speed.
Remedy: Replace the laser unit. Replace the DC controller PCB. Check the wiring.

Code: E191-0000

Description: There is an error in the communication with the high-voltage power supply.
The data transmission/reception does not end normally 500 msec after the most recent transmission/reception of data ended normally.
Remedy: Replace the high-voltage power supply. Replace the DC controller PCB.

Code: E197-0000

Description: Error in communication of laser driver PCB
Communication error with IMG1L (communication data)
Remedy: - Check routing (wiring) - Replace the laser unit - Replace DC controller PCBP

Code: E197-0001

Description: Error in communication of laser driver PCB
Communication error with IMG1L. (Serial communication ENG)
Remedy: - Check routing (wiring) - Replace the laser unit - Replace DC controller PCBP

Code: E197-0003

Description: Error in communication of laser driver PCB
Disconnection of laser harness
Remedy: - Check routing (wiring) - Replace the laser unit - Replace DC controller PCB

Code: E202-0001

Description: There is an error in the detection of the CCD home position.
The attempt to detect the home position fails when the CCD is moved forward.
Remedy: Disconnect and then connect the harness connector. Replace the optical HP sensor, optical motor, and reader controller PCB.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie