Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Canon iR3570 — Trang 4/24

Code: E110-0002

Description: The scanner motor is faulty.
The speed lock signal indicates a deviation 10 times in sequence at intervals of 10 msec after the signal has indicated a locked state.
Remedy: Replace the laser unit. Replace the DC controller PCB. Check the wiring.

Code: E110-0003

Description: The scanner motor is faulty.
With the image clock switched over, the scanner motor speed lock signal does not indicate a locked state 6.5 sec after a switchover is made from low to normal speed or 8 sec after a switchover is made from normal to low speed
Remedy: Replace the laser unit. Replace the DC controller PCB. Check the wiring.

Code: E191-0000

Description: There is an error in the communication with the high-voltage power supply
The data transmission/reception does not end normally 500 msec after the most recent transmission/reception of data ended normally.
Remedy: Replace the high-voltage power supply. Replace the DC controller PCB.

Code: E202-0001

Description: There is an error in the detection of the CIS home position.
The attempt to detect the home position fails when the CIS is moved forward
Remedy: Disconnect and then connect the harness connector. Replace the following as necessary: scanner home position sensor, scanner motor, reader controller PCB.

Code: E202-0002

Description: There is an error in the detection of the CIS home position.
The attempt to detect the home position fails when the CIS is moved back.
Remedy: Disconnect and then connect the harness connector. Replace the following as necessary: scanner home position sensor, scanner motor, reader controller PCB.

Code: E225-0001

Description: The light intensity of the CIS is faulty.
During shading operation, the intensity is below a specific level.
Remedy: Disconnect and then connect the flexible cable. Replace the following as necessary: flexible cable, CIS, reader controller PCB.

Code: E225-0002

Description: The light intensity of the CIS is faulty.
During DF stream reading, the sheet-to-sheet light intensity is faulty.
Remedy: Disconnect and then connect the flexible cable. Replace the following as necessary: flexible cable, CIS, reader controller PCB.

Code: E227-0001

Description: The reader unit power supply is faulty.
At time of power-on, the 24-V port is off.
Remedy: Disconnect and then connect the power supply harness connector. Replace the power supply.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie