Description: The rotation of the drum motor is faulty.
No clock pulse arrives for 2 sec or more after the drum motor drive signal (DMFG) has been generated.
Remedy: - Check if the connector (J1720) of the relay PCB is mounted properly. - Check if the connector (J512) of the DC controller PCB is mounted properly. - Check if the connecter (J601, J602) of the drum motor is mounted properly. - Replace the drum motor. - Replace the DC controller PCB.
Description: The lock of the waste toner feed screw is detected.
The waste toner feed screw fails to rotate normally, and the switch MSW2 is pressed multiple times within a specific period of time.
Remedy: - Re-mount the waste toner pipe. - Replace the waste toner pipe. - Replace the waste toner clog detecting switch. - Replace the DC controller PCB. Caution You will have to clear the error in service mode (COPIER>FUNCTION>CLEAR>ERR).
Description: The rotation of the fixing motor is faulty.
The motor clock signal is not detected for 2 sec or more after the fixing motor drive signal has been generated.
Remedy: - Check if the connecter (J651, J652) of the fixing motor is mounted properly. - Replace the fixing motor. - Replace the relay PCB. - Replace the DC controller PCB.
Description: The rotation of the pickup motor is faulty.
The motor lock signal is not detected for 2 sec or more after the pickup motor drive signal has been generated.
Remedy: - Check if the connecter (J621, J622) of the pickup motor is mounted properly. - Replace the pickup motor. - Replace the relay PCB. - Replace the DC controller PCB.
Description: The waste toner case is full, or the waste toner case full sensor is faulty.
More than a specific number of pages are printed without disposing of the waste toner after the waste toner case has been found to be full.
Remedy: - Dispose the waste toner in the case. - Check the operation of the base plate of waste toner case. - Check if the connector (J514) of the DC controller PCB is mounted properly. - Replace the waste toner full sensor. - Replace the DC controller PCB.
Description: The difficulty providing toner inside the hopper developing assemblies is detected.
Although the developing assembly is supplied with toner, the absence of toner inside it is detected for 3 sec or more.
Remedy: - Replace the magnet roller drive clutch. - Replace the toner feed motor (M18). - Replace the toner sensor. Caution You will have to clear the error in service mode (COPIER>FUNCTION>CLEAR>ERR).
Description: The difficulty providing toner inside the hopper developing assemblies is detected.
The power is turned off and then on without clearing the error.
Remedy: - Clear the error in service mode (COPIER>FUNCTION>CLEAR>ERR).
Nhận ưu đãi sớm nhất khi chương trình diễn ra
Đăng ký nhận bản tin
Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này.
Chính sách cookie
Những cookie này là cần thiết để trang web hoạt động đúng cách.
Những cookie này giúp chúng tôi hiểu cách khách truy cập tương tác với trang web.
Những cookie này được sử dụng để cung cấp quảng cáo cá nhân hóa.