Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Canon LBP5200 — Trang 3/3

Code: E078

Display: E078
Description: Secondary transfer roller engaging mechanism abnormality
Remedy: 1) Poor contact in the roller engaging sensor connector Action: Reconnect the J714 for the roller engaging sensor and J115 on the DC controller PCB. 2) Poor contact in the roller engaging clutch connector Action: Reconnect the J114 on the DC controller PCB. 3) Defective roller engaging clutch Action: Disconnect the J114 on the DC controller PCB. Measure resistance between the J114-2 and J114-1. If the result is not about 150 Om, replace the roller engaging clutch. 4) Defective spring for the engaging lever Action: If it is out of place, reset it properly. If it is deformed, replace it. 5) Defective engaging lever Action: Replace the secondary transfer roller or engaging lever. 6) Defective roller engaging cam Action: Replace the EP-87 drum cartridge. 7) Defective roller engaging sensor Action: Replace the main drive unit. 8) Defective DC controller PCB Action: Replace it.

Code: E100

Display: E100
Description: Optical Unit (Laser/scanner Unit) Failure
Remedy: 1) Poor contact in the laser drive signal line connector Action: Reconnect the J11 on the laser driver PCB and J102 on the DC controller PCB. 2) Poor contact in the BD detection line connector Action: Reconnect the J131 on the BD PCB and J103 on the DC controller PCB. 3) Poor contact in the scanner motor connector Action: Reconnect the J221 for the scanner motor and J103 on the DC controller PCB. 4) Defective laser/scanner unit Action: Replace it. 5) Defective DC controller PCB Action: Replace it.

Code: E196

Display: E196
Description: DC controller memory failure
Remedy: 1) Defective DC controller PCB Action: Replace it.

Code: E197

Display: E197
Description: Engine communication error
Remedy: 1) Fault on the DC controller PCB Action: Replace the DC controller PCB.

Code: E747

Display: E747
Description: Fault in the interface controller memory
Remedy: 1) Fault on the interface controller PCB Action: Replace the interface controller PCB.

Code: E805

Display: E805
Description: Fan (FM721) Failure
Remedy: 1) Defective cooling fan Action: If a voltage between the J123-1 and J123-3 on the DC controller PCB changes from 0 V to 24 V right after turning on the printer, replace the cooling fan. 2) Poor contact in the cooling fan drive connector Action: Reconnect the J213 for the cooling fan and J123 on the DC controller PCB. 3) Defective DC controller PCB Action: Replace it.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie