Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Epson Stylus Pro 7000 — Trang 2/4

Code: 00010006

Description: CR motor overcurrent
Feedback from the CR motor (IC33) driver’s 10-pin output (Sense signal) indicates that the CR motor’s current is irregular.
Remedy: • Check the CR cover, slightly loosen screws if necessary • Check the cutter housing, slightly loosen screws if necessary • Make sure no foreign material or ink tubes (from pump assembly) are blocking the carriage path (see “Removing the Maintenance Assembly” on page 143 for reassembly points) • Replace the CR motor • Replace the Main Board

Code: 00010007

Description: CR in-position time-out
The in-position time is the amount of time the printer waits to make sure the carriage is not moving when the carriage comes to a stop. The linear encoder is activate for the predetermined “in-position time” and if the encoder sends a pulse, this means the carriage is moving even though it is supposed to be at a full stop, this generates an error.
Remedy: • Replace the encoder sensor • Replace the CR motor • Replace the Main Board

Code: 00010008

Description: Servo interrupt watchdog time-out error
Servo interrupt watchdog time-out error due to motor-drive control related error
Remedy: Replace the Main Board

Code: 00010009

Description: System interrupt watchdog time-out error
System interrupt watchdog time-out error due to sensor-related errorror occurs.
Remedy: Replace the Main Board

Code: 0001000A

Description: CR origin sensor malfunction
CR home position sensor malfunction
Remedy: • Make sure the CR HP sensor is not twisted or bent • Replace the CR HP sensor • Replace the Main Board

Code: 0001000B

Description: PF origin sensor malfunction
PF home position sensor malfunction means motor replacement
Remedy: • Check the PF motor and sensor connections • Replace the PF motor (internal sensor) • Replace the Main Board

Code: 0001000C

Description: PG origin sensor malfunction
(may indicate PG motor malfunction)
Remedy: Make sure there is no ink or dust on the surface of the sensor. If this does not solve the problem, check the PG sensor connection. If there still is a problem, try the following. • Replace the PG sensor • Replace the PG motor • Replace the Main Board

Code: 0001000D

Description: Cover sensor malfunction (00)
Right sensor (HP side) One or both cover open sensors (interlock switch) located at either end of the cover shaft is malfunctioning.
Remedy: Make sure the sensor(s) are properly installed. If that does not solve the problem, check the cover open sensor connection. If there still is a problem, try the following. • Replace the malfunctioning cover sensor • Replace the Main Board
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie