Causes: • The head thermistor is faulty. • The temperature of the thermistor is lower than minus 20 degrees C or higher than 100 degrees C. • The Head FFC is disconnected, or its contact is poor.
Remedy: 1. Check the connection status of the Head FFC and correct it if necessary. 2. Replace the PRINT HEAD .
Causes: • The Pressure Sensor is ON when an ink pressurizing operation is not performed. (disconnection of the Pressure Sensor connector, malfunction of the Pressure Sensor, or Main Board failure) • The inside pressure cannot be reduced to the same level as atmospheric pressure. (valve failure, Regulator Solenoid failure, Pressure Tube failure, or Main Board failure)
Remedy: 1. Reconnect the Pressure Sensor connector securely. 2. Connect the Pressure Tube. 3. Replace the PUMP ASSY., SUPPLY . 4. Replace the BOARD ASSY., MAIN .
Causes: • Exact detection of printing positions is impossible due to dirt or scratches on the Timing Fence or the CR Encoder. • Malfunction of the program
Remedy: 1. Replace the SCALE, CR . 2. Replace the CR Encoder Sensor . 3. Execute the CR Encoder Sensor Adjustment . 4. Installing Firmware
Description: SDRAM error
The printer causes this error and stops operation when it detects a bit error by the SDRAM memory check performed during the power-on sequence.
Causes: • SDRAM reading/writing error • SDRAM failure • The address/data bus on the Main Board is broken or its contact is poor.
Remedy: Replace the BOARD ASSY., MAIN .
Nhận ưu đãi sớm nhất khi chương trình diễn ra
Đăng ký nhận bản tin
Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này.
Chính sách cookie
Những cookie này là cần thiết để trang web hoạt động đúng cách.
Những cookie này giúp chúng tôi hiểu cách khách truy cập tương tác với trang web.
Những cookie này được sử dụng để cung cấp quảng cáo cá nhân hóa.