• Code: 15AD
• Description: Reel Motor driving time-out error
  Abnormally-long driving duration of the Reel Motor was detected. • Irregular load • Firmware becomes out of control.
• Remedy: Replace the Main Board.

• Code: 15AE
• Description: Reel Motor velocity deviation error
  The Reel Motor was driven at a speed abnormally faster than a predetermined one during acceleration or deceleration. • Irregular load • Reel Motor encoder failure • Reel Motor failure • Sub-F Board failure • Reel Motor driver failure
• Remedy: 1. Replace the Reel Motor. 2. Replace the Sub-F Board. 3. Replace the Main Board.

• Code: 15AF
• Description: Reel Motor lock error
  • Connection failure of the Reel Motor. • The Reel Motor was driven at a speed abnormally slower than a predetermined one during operation. • Irregular load • Reel Motor encoder failure • Reel Motor failure
• Remedy: Replace the Reel Motor.

• Code: 1610
• Description: Roll/Reel Units mismatch error
  The combination of the Roll Unit and Reel Unit may be wrong; one of the units may be an optional unit.
• Remedy: Correct the combination of the Roll Unit and Reel Unit to either both are standard or both are optional.

• Code: 1611
• Description: Roll Unit undetectable error
  The Roll Unit could not be detected during mechanism initialization process.
• Remedy: Connect the connector of the Roll Unit.

• Code: 1612
• Description: Roll Unit undetectable error at the start of operation
  When the ATC Motor started to operate, it was detected that the Roll Unit status is different from that detected during mechanism initialization process.
• Remedy: 1. Connect the connector of the Roll Unit. 2. Turn the printer off and back on.

• Code: 1613
• Description: Roll Unit undetectable error during operation
  The connector of the Roll Unit was disconnected during the ATC Motor was operating.
• Remedy: Connect the connector of the Roll Unit.

• Code: 1614
• Description: Reel Unit undetectable error at the start of operation
  When the Reel Motor started to operate, it was detected that the Reel Unit status is different from that detected during mechanism initialization process.
• Remedy: 1. Connect the connector of the Reel Unit. 2. Turn the printer off and back on.