Code :

Code: 40.00.02
Display: 40.00.02 Embedded I/O buffer overflow To continue, touch “OK”
Description: The product has experienced a JetDirect buffer overflow.
Remedy: 1. Touch the OK button to print the transferred date (some data might be lost). 2. Check the host configuration.

Code: 40.00.03
Display: 40.00.03 EIO <X> buffer overflow To continue, touch “OK”
Description: Too much data was sent to the EIO card in the specified slot (x). An incorrect communications protocol might be in use.
Remedy: Touch the OK button to print the transferred date (some data might be lost).

Code: 40.00.04
Display: 40.00.04 EIO <X> bad transmission To continue, touch “OK”
Description: The connection between the product and the USB device has been broken.
Remedy: 1. Touch the OK button to clear the error message and continue printing. 2. Remove, and then reinstall the USB device.

Code: 40.00.05
Display: 40.00.05 Embedded I/O bad transmission To continue, touch “OK”
Description: The USB device has been removed.
Remedy: 1. Touch the OK button to clear the error message (data will be lost). 2. Install the USB device.

Code: 40.0X.05
Display: 40.0X.05 USB storage accessory removed
Description: X = 1, 2, 3, 5, or 6; information code. The USB storage accessory was removed.
Remedy: No action necessary.

Code: 41.01.YZ
Display: 41.01.YZ
Description: Event log error message: 41.01.YZ. An unknown misprint error occurred on the product. Y = Type, Z = Tray
• Y = 0: Photo Media (1, 2, or 3) • Y = 1: Auto Sense (Normal) • Y = 2: Normal (typed not from Auto Sense) • Y = 3: Light media 1, 2, or 3 mode • Y = 4: Heavy media 1 • Y = 5: Heavy media 2 • Y = 6: Heavy media 3 • Y = 7: Glossy media 1 • Y = 8: Glossy media 2 • Y = 9: Glossy media 3 • Y = A: Glossy film • Y = B: OHT • Y = C: Label • Y = E: Rough • Y = F: Other mode • Z = 0: From unknown tray • Z = 1: From Tray 1 • Z = 2: From Tray 2 • Z = 3: From Tray 3 • Z = 4: From Tray 4 • Z = 5: From Tray 5 • Z = 6: From Tray 6 • Z = 7: From Tray 7 • Z = 8: From Tray 8 • Z = 9: From Tray 9 • Z = D: From duplex
Remedy: 1. To continue printing, press . 2. Turn the product off, and then on again. 3. Resend the print job. 4. Replace or reseat the toner cartridge to test. 5. Check the toner cartridge before replacing any other parts (HP original?, connectors, etc.). 6. Reseat the connections to the laser/scanner and the DC controller. 7. If the error persists, replace the laser/scanner. 8. Replace the upper cable guide assembly. 9. Replace the DC controller.

Code: 41.02.00
Display: 41.02.00
Description: A beam detected misprint error.
Remedy: 1. To clear the error message, touch OK. 2. If the error persists, turn the product off, and then on again. 3. Resend the print job. 4. Reseat the connections to the laser/scanner and the DC controller. 5. Replace the laser/scanner.