Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi HP LaserJet P3005dn

Code: -

Display: Access Denied MENUS LOCKED
Description: The device administrator has enabled the control-panel security mechanism. You cannot modify control-panel settings in this circumstance. The message disappears after a few seconds, and the device returns to Ready or BUSY state.
Remedy: Contact the device administrator to change settings.

Code: -

Display: ACTION NOT CURRENTLY AVAILABLE ON TRAY X
Description: You are trying to set duplex registration for a tray that is configured for ANY SIZE or ANY CUSTOM. Duplex registration is not available when the tray size is set to either of these settings.
Remedy: Change the size setting for the tray.

Code: -

Display: CHOSEN PERSONALITY NOT AVAILABLE
Description: The device encountered a request for a personality that did not exist in the device.
Remedy: 1. Press "OK" to continue. 2. Try a different driver.

Code: -

Display: CLOSE TOP COVER
Description: Door switch SW501 is signalling that the cartridge door is open. If the cartridge door is open, the main motor will not rotate during device power-up.
Remedy: The wires for switch SW501 are hard-wired to the ECU. Verify that the wires from the ECU are installed on the correct terminals of switch SW501.

Code: -

Display: CLOSE TOP COVER AND FRONT DOOR
Description: Door switch SW501 is signalling that the cartridge door is open. If the cartridge door is open, the main motor will not rotate during device power-up.
Remedy: The wires for switch SW501 are hard-wired to the ECU. Verify that the wires from the ECU are installed on the correct terminals of switch SW501.

Code: -

Display: CODE CRC ERROR
Description: An error has occurred during a firmware upgrade.
Remedy: 1. Reinstall the firmware. 2. If the problem persists, contact HP Support.

Code: -

Display: INFLATE FAILURE
Description: An error has occurred during a firmware upgrade.
Remedy: 1. Reinstall the firmware. 2. If the problem persists, contact HP Support.

Code: -

Display: RAM DISK IS WRITE PROTECTED
Description: The file system is protected and no new files can be written to it.
Remedy: 1. To enable writing to the RAM disk memory, use HP Web Jetadmin to turn off write protection. 2. To remove this message from the display, press "OK"
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie