Causes: 1. Fuser temperature does not start rising up within 150 seconds since you have turned on the machine. 2. Fuser temperature becomes lower than 80 degrees Centigrade since the machine has idled.
Causes: 1. Developer Unit Home Position Signal (DEVE-HP) does not change H although 30 seconds has passed since you turned on the machine. 2. Connector (J29) to the Developer Unit is disconnected. (DEVE_CN = “L”, when it is connected.)
Causes: 1. The Status Signal continues to be L for more than 100 milliseconds when the Counter is counting. 2. The Status Signal continues to be H for more than 100 milliseconds when the Counter is not counting.
Causes: 1. In case one of the Cutter Home Position Signal 1 or 2 stays H and the other does not show L when the Cutter Motor is not rotating. 2. It takes longer than 1.5 seconds to move the Cutter from one home position to the another one. 3. After the Cutter worked, when Flapper Detective Signal does not change from L to H, and L again.