Causes: 1. Fuser temperature does not start rising up within 150 seconds since you have turned on the machine. 2. Fuser temperature becomes lower than 80 degrees Centigrade since the machine has idled.
Causes: 1. Developer Unit Home Position Signal (DEVE-HP) does not change H although 30 seconds has passed since you turned on the machine. 2. Connector (J29) to the Developer Unit is disconnected. (DEVE_CN = “L”, when it is connected.)
Causes: 1. The Status Signal continues to be L for more than 100 milliseconds when the Counter is counting. 2. The Status Signal continues to be H for more than 100 milliseconds when the Counter is not counting.
Causes: 1. Cutter Home Position Signal (CUTHP) remains H while Cutter Motor stays off. 2. When Cutter works, (CUTHP) signal changes L - H - L. If the time exceeds 1.5sec (in case of Initialization, 4sec), E-07 appears. 3. When Paper Sensor PH4 (P_CUT) does not change L - H - L after Cutter worked.