Code :

Code: CA052
Description: Controller hardware error • A controller hardware error is detected in the network I/F.
Causes: MFP board (MFPB)
Remedy: 1 Check to see if the following setting has been correctly made: [Service Mode] - [System 2] - [Image Controller Setting]. If changing the setting, turn OFF the main power switch and turn it ON again after 10 seconds or more. . . 2 Check the connectors of the MFP board (MFPB) for proper connection and correct as necessary. . . 3 Change MFPB

Code: CA053
Description: Controller start failure • A controller start failure is detected in the controller interface.
Causes: MFP board (MFPB)
Remedy: 1 Check to see if the following setting has been correctly made: [Service Mode] - [System 2] - [Image Controller Setting]. If changing the setting, turn OFF the main power switch and turn it ON again after 10 seconds or more. . . 2 Check the connectors of the MFP board (MFPB) for proper connection and correct as necessary. . . 3 Change MFPB

Code: CC001
Description: Vendor connection failure • It is detected that communications with the vendor are interrupted for a given period of time or more with “Installed” selected for the setting of vendor installation.
Causes: Printer control board (PRCB) Coin vendor (Japan) Coin vendor kit (North America, Europe)
Remedy: 1 Check the vendor connector for proper connection and correct as necessary. 2 Check the PRCB connector for proper connection and correct as necessary. 3 Change PRCB

Code: CC151
Description: ROM contents error upon startup (MSC) • A fault is detected in a sequence of ROM contents check of the MFPB during starting
Causes:
Remedy: 1 Check the ROM version. 2 Rewrite the firmware. 3 Replace the appropriate board.

Code: CC152
Description: ROM contents error upon startup (scanner) • A fault is detected in a sequence of ROM contents check of the MFPB during starting
Causes:
Remedy: 1 Check the ROM version. 2 Rewrite the firmware. 3 Replace the appropriate board.

Code: CC153
Description: ROM contents error upon startup (PRT) • A fault is detected in a sequence of ROM contents check of thePRCB during starting.
Causes:
Remedy: 1 Check the ROM version. 2 Rewrite the firmware. 3 Replace the appropriate board.

Code: CC155
Description: Finisher ROM error • Data of flash ROM of the finishing options is determined to be faulty when the power is turned ON.
Causes: DF control board (DFCB)
Remedy: 1 Disconnect and then connect the power cord. Turn OFF the main power switch, wait for 10 sec. or more, and turn ON the main power switch. 2 Rewrite firmware. 3 Change FSCB

Code: CC156
Description: ADF ROM error • Upgrade of the firmware has not been successful.
Causes: DF control board (DFCB)
Remedy: 1 Disconnect and then connect the power cord. Turn OFF the main power switch, wait for 10 sec. or more, and turn ON the main power switch. 2 Rewrite the firmware. 3 Change DFCB