• Code: C8102
• Description: Pressure/retraction mechanism failure at the turnover section See DF-608
• Remedy:

• Code: C8103
• Description: Lift up mechanism failure See DF-608
• Remedy:

• Code: C8104
• Description: Original glass travel failure See DF-608
• Remedy:

• Code: C8105
• Description: Original feeding interval failure See DF-608
• Remedy:

• Code: C8302
• Description: Cooling fan failure See DF-608
• Remedy:

• Code: C9401
• Description: Exposure lamp’s failure to turn ON
  • The output from the CCD sensor is a predetermined value or less during CCD sensor gain adjustment.
• Remedy: 1 Check the flat cable for proper connection and correct or change as necessary. 2 Change scanner assy. 3 Change IPB MFPB.

• Code: C9402
• Description: Exposure lamp turning ON at abnormal timing
  • The average output value of the CCD sensor with the scanner at its standby position is a predetermined value or more at the end of a scan job.
• Remedy: 1 Check the flat cable for proper connection and correct or change as necessary. 2 Change scanner assy. 3 Change IPB MFPB.

• Code: CA051
• Description: Standard controller configuration failure
  • The controller of the printer control board (PRCB) is faulty.
• Remedy: 1 Check to see if the following setting has been correctly made: [Service Mode] - [System 2] - [Image Controller Setting]. If changing the setting, turn OFF the main power switch and turn it ON again after 10 seconds or more. 2 Check the connectors of the printer control board (PRCB) for proper connection and correct as necessary. 3 Change PRCB.