Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Konica-Minolta bizhub Pro 1050P — Trang 32/42

Code: SC53-17

Description: The blowout of the sensor 5VICP is detected. An error detection signal of the blowout of the 5VICP is detected.
Causes: Printer control board (PRCB)
Remedy: The main body stops immediately to turn OFF the RL1 (main).

Code: SC53-18

Description: The fall-off of the erase lamp (EL) CN is detected. When turning ON the power, an error detection signal (fall-off) is detected a specified period of time after the fall-off detection control signal of the EL CN turns ON.
Causes: Erase lamp (EL)
Remedy: The main body stops immediately to turn OFF the RL1 (main).

Code: SC53-19

Description: An M5 EM error detection signal is detected twice in succession a specified period of time after the conveyance motor (M5) turns ON.
Causes: Conveyance motor (M5) Printer control board (PRCB)
Remedy: The main body stops immediately to turn OFF the RL1 (main).

Code: SC53-20

Description: An M5 EM error detection signal is detected twice in succession a specified period of time after the ADU reverse/exit motor (M31) turns ON.
Causes: ADU reverse paper exit motor (M31) Printer control board (PRCB)
Remedy: The main body stops immediately to turn OFF the RL1 (main).

Code: SC56-02

Description: The communication between the image processing board (IPB) and the operation board /1 (OB1) is checked. An initial communication from the main body to the operation board is not sent within 30 seconds after the power is turned ON.
Causes: Operation board /1 (OB1) Overall control board (OACB)
Remedy: The main body stops immediately to turn OFF the RL1 (main).

Code: SC60-01

Description: Although the main body sent out data according to the data transmission request by the DF, the same request is received again.
Causes: Image processing board (IPB)
Remedy: If there is a copy being made, the main body and the DF complete the paper exit before stopping operations. Turn OFF the RL1 (main).

Code: SC60-02

Description: When a checksum error or an SRGA reception error was detected while in the reception in serial communication, a signal was sent to make a request for sending data again. And when data is being received upon this request, a checksum error or an SRGA reception error is detected again.
Causes: RADF control board (ADFCB)
Remedy: If there is a copy being made, the main body and the DF complete the paper exit before stopping operations. Turn OFF the RL1 (main).

Code: SC60-03

Description: When the main power switch (SW1) is ON, there is no response to the initial communication request from the main body to the DF even after a specified period of time elapses.
Causes: RADF control board (ADFCB)
Remedy: If there is a copy being made, the main body and the DF complete the paper exit before stopping operations. Turn OFF the RL1 (main).
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie