Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Konica-Minolta bizhub Pro 920 — Trang 23/32

Code: SC53-07

Description: The blowout of a 5V ICP for the AC drive board (ACDB) is checked. In the serial initial communication, a signal of the blowout of a 5V ICP (AC drive) is detected.
Causes: Printer control board (PRCB) AC drive board (ACDB) DC power supply /1 (DCPS1) Loose connection

Code: SC53-08

Description: The 12V power source in the printer control board (PRCB) is checked. An error detection signal of the 12V in PRCB is detected.
Causes: Printer control board (PRCB) AC drive board (ACDB) DC power supply /1 (DCPS1) Loose connection

Code: SC53-11

Description: The 24V power source for the SD/CL in the printer control board (PRCB) is checked. At the start, an error detection signal (blowout of ICP for the solenoid/clutch) is detected, and an error detection signal (24V cut off) is also detected.
Causes: Each of the solenoids Each of the clutches Printer control board (PRCB) Wiring harness earth fault

Code: SC53-12

Description: The blowout of ICP for the SD/CL in the printer control board (PRCB) is checked. At the start, an error detection signal (blowout of ICP for the solenoid/clutch) is detected. However, an error detection signal (24V cut off) is not detected.
Causes: Each of the solenoids Each of the clutches Printer control board (PRCB) Wiring harness earth fault

Code: SC60-01

Description: Although the main body sends out data according to the data retransmission request made by the DF, a retransmission request signal is received again.
Causes: Overall control board (OACB) DF control board (DFCB) Communication system cable

Code: SC60-02

Description: When a checksum error or an SRGA reception error was detected while in the reception in serial communication, a signal was sent to make a request for sending data again. And when data is being received upon this request, a checksum error or an SRGA reception error is detected again.
Causes: Overall control board (OACB) DF control board (DFCB) Communication system cable

Code: SC60-03

Description: When the main power switch (SW1) is ON, there is no response to the initial communication request from the main body to the DF even after a specified period of time elapses.
Causes: DF control board (DFCB)

Code: SC60-11

Description: When the main power switch (SW1) is ON, a region into which no write was made by the ISW is detected in the DF control program.
Causes: DF control board (DFCB) DF program
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie