Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Kyocera FS6020 — Trang 2/3

Code: 4200

Description: laser output error
• The pin photo signal (PDN) is not output within a specified time after the polygon motor ready signal (MOTRDYN) becomes ready (L level).

Code: 6000

Description: fixing heater lamp/fixing thermistor error
• The fixing thermistor disconnection detection circuit in the engine/high voltage PWB outputs the disconnection detection signal (THDEAD) to the CPU more than a specified time after power is turned on. • The fixing temperature does not rise at least 1 °C when the fixing heater lamp is continuously on for approximately 20 seconds during printer warm-up or in the standby mode. • The fixing temperature does not rise at least 1 °Cwhen the fixing heater lamp is continuously on for approximately 15 seconds during printing. • The fixing temperature does not lower when the fixing heater lamp is off for a specified time or more. * The fixing temperature is the average value calculated using the input voltage from the fixing thermistor detected several times in a specified time to avoid influence of noise and so on.

Code: 6020

Description: abnormally high fixing temperature error
• The fixing heater lamp runaway protection circuit in the engine/high voltage PWB outputs continuously the abnormally high temperature detection signal (HTEMPN) to the CPU for a longer time than specified.

Code: 6400

Description: fixing heater lamp control zero-cross signal detection error
• The zero-cross signal (ZCROSS) that is output from the power source PWB and input to the CPU on the engine/high voltage PWB is not input for a specified time.

Code: F0

Description: communication error between the operation panel PWB and main PWB
• Serial communication between the operation panel PWB and the main PWB malfunctions.{

Code: F010

Description: code ROM checksum error
• Checksum of the code ROM PWB attached to the socket (YS1) on the main PWB malfunctions.

Code: F020

Description: main PWB RAM checksum errorion error
Checksum in the standard RAM mounted on the main PWB or in optional expansion memory is not correct. {

Code: F030

Description: main PWB controller errororion error
• The controller (CPU) on the main PWB malfunctions.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie