Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Kyocera FS7000 plus

Code: A1

Description: Uninstalled waste toner conveyer
The waste toner conveyer is not installed, or the conveyer is clogged inside with waste toner.
Causes: • Waste toner converyer is not installed. • The belt is not rotating in the conveyer unit. • Connection failure between the CON1 board and the conveyer board • Engine gate arrays (U2/U6) failure • Defective LED driving circuit on the engine board. Defective LED on the conveyer board. Connection failure between the waste toner conveyer board and the photo transistor. Defective photo transistor. • Contaminated waste toner conveyer housing or photo receptor. • The waste toner driving system in the toner container is not working properly.

Code: A2

Description: Fuser overheating
The fuser unit is overheating.
Causes: • Defective photo-coupler (low voltage) for heaters • Defective engine gate array U2 • Defective heater control circuit (engine board) or heater temperature detector

Code: A3

Description: Fuser heater disconnection
Either or both heater lamp(s) is blown out.
Causes: • Blown-out heater lamp(s) • Defective connection between the engine board and the low voltage supply. • Malfunctioning engine CPU • Defective heater disconnection sensor circuit in the low voltage supply • Defective thermo-cut (Replace the fuser unit.)

Code: A4

Description: Developer unit life-fuse error
The life fuse won’t cut in the developer unit.
Causes: • Defective engine gate array • Defective fuse cut circuit on the engine board

Code: B1 ... B6

Description: Feed cassette bottom plate motor error
The feed cassette bottom plate motor won’t revolve.
Causes: • Excessive torque on the motor (activating the current protection circuit) • Stuck motor • Defective feed board PU (U1) • Defective motor driver circuit (transistors) or over-current detector circuit

Code: C1

Description: Duplex communication error
Communication error between the duplexer and the printer.
Causes: • Defective engine gate array (U6) • Defective engine CPU (U1) • Duplexer CPU (U1) malfunction • Defective U2, U5, U6 on duplexer board • Defective connection between KP-544 (YC4) and KP-568 (YC1), KP-568 (YC3) and liaison connector, liaison connector and KP-587 (YC1), or defective liaison connector

Code: C2

Description: Duplex printing registration error
The duplexer’s registration boards are not in the home position.
Causes: • Defective registration motor • Defective home position sensor • Malfunctioning motor driving circuit (U2/U6/U7) on duplexer board • Defective duplxer CPU (U1) • Connection error between the registration motor and KP-587 (YC5), or home position sensor and KP-587 (YC7)

Code: C4

Description: DF-30 IPC communication error
Communication error with the document finisher DF-30
Causes: • Defective IPC (intelligent protocol controller) LSI (communication chip) • Defective interface connector/cable
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie