Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Kyocera KMC850

Code: C0030

Description: Fax control PCB problem • Processing with the fax software was disable due to a hardware or software problem.
Causes: Defective fax control PCB.
Remedy: Replace the fax control PCB and check for correct operation.

Code: C0070

Description: Abnormal detection of fax control PCB incompatibility • In the initial communication with the fax control PCB, any normal communication command is not transmitted.
Causes: Defective fax control PCB.
Remedy: Replace the fax control PCB and check for correct operation.

Code: C0100

Description: Scanner main PCB backup memory device problem • Writing or erasing has not completed even after a certain time.
Causes: Defective scanner main PCB.
Remedy: Replace the scanner main PCB and check for correct operation.

Code: C0110

Description: Backup memory data problem A • Data in the specified area of the backup memory does not match the specified values.
Causes: Problem with the backup memory data.
Remedy: Turn safety switch 1 off and back on and run maintenance item U020 to set the contents of the backup memory data again.

Code: C0120

Description: Drum EEPROM read error • The ASIC of engine controller PCB does not access to the EEPROM of drum PCB normally.
Causes: Poor contact in the connector terminals. Defective engine controller PCB or drum PCB.
Remedy: Check the connection of connector YC17 on the engine controller PCB and the continuity across the connector terminals. Repair or replace if necessary. Replace the engine controller PCB or drum unit and check for correct operation.

Code: C0130

Description: Backup memory device problem
Causes: Defective scanner main PCB. Data damage of EEPROM.
Remedy: Replace the scanner main PCB and check for correct operation. Contact the Service Administrative Division.

Code: C0140

Description: Backup memory data problem
Causes: Data damage of EEPROM.
Remedy: Contact the Service Administrative Division.

Code: C0150

Description: Backup memory device problem • Data cannot be read or written in the flash ROM.
Causes: Defective engine controller PCB.
Remedy: Replace the engine controller PCB and check for correct operation.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie