Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Lexmark C760 — Trang 17/18

Code: 978

Description: Standard Network or Network Card x
Remedy: Bad checksum while programming network Network Card x port.

Code: 979

Description: Standard Network or Network Card X
Remedy: Flash parts failed while programming Network Card x port.

Code: 980

Description: <device> comm
Remedy: Engine is experiencing unreliable communications to the specified device. Errors 980 through 984 indicate the specified device has detected a Paper Port communication failure.

Code: 981

Description: <device> comm
Remedy: Engine protocol violation detected by the specified device. • Engine • Duplex Option • Tray x (where x=1,2,3,4, or 5)

Code: 982

Description: <device> comm
Remedy: Communications error detected by the specified device. Output Bin (where x=1,2,3,or 6) Note: This message is used for single bin output devices. Bins x to y (where x to y= 1 to 5, 2 to 6, or 6 to 10)

Code: 983

Description: <device> comm
Remedy: Invalid command received by the specified device. Note: This message is used for multiple bin output devices. Note: Check the autoconnects above and below the failing option to make sure they are seated and connected correctly. Go to service check for the device indicated.

Code: 984

Description: <device> comm
Remedy: Invalid command parameter received by the specified device.

Code: 990

Description: <device> This error message indicates that an equipment check condition has occurred in the specified device, but the device is unable to identify the exact component failure. Note: <device> can be one of the following: • Duplex option • Tray x (where x=1,2,3,4, or 5) • Output bin x (where x=1,2,3, or 6) Note: This message is used for single bin output devices. Output bin x to y (where x=1 to 5, 2 to 6, or 6 to 20) Note: This message is used for multiple bin output devices. Go to the service check for the device indicated.
Remedy: 1 Make sure the autocompensator cable is correctly installed at the tray system board. Is the cable correctly installed? Go to step 2 Install the cable correctly 2 Make sure the drive assembly cable is connected correctly to the tray system board. Is the cable correctly installed? Go to step 3 Install the cable correctly 3 Check for worn or broken parts in the autocompensator and drive assemblies. Are any parts worn, broken, or damaged? Replace the assembly that has the defective parts Replace the FRUs in the following order: 1. Electronic/ size sensing assembly 2. Autocompensator assembly 3. Drive Assembly
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie