Display: Cartridge Error and Faxes in Memory or Unable to Authenticate [x] Ink Cartridge or The following Cartridges cannot be authenticated:
Description: Unable to authenticate cartridge
Remedy: Open the printer cover, and check the ink cartridges for proper installation. If properly installed, then replace the ink cartridges. Service: Inspect the tank contact card: • Wipe it using a clean, lint-free cloth. • If the contacts show signs of damage, replace the tank contact card
Remedy: Check if media is present. If present, check if media is supported by the printer. Unplug the printer from the electrical outlet, wait for 10 seconds, and then plug the printer back in. If the problem remains, then replace the printer. Service: Perform a sensor test. Go to “Sensor Tests”. If the problem remains, replace the print engine.
Display: Unrecoverable Scan Error The Printer must reboot to recover.
Description: Unrecoverable scan error
Remedy: Unplug the printer from the electrical outlet, wait for 10 seconds, and then plug the printer back in. If the problem remains, then replace the printer. The CIS assembly does not move. If the CIS module assembly does not move, then check connector J5 on the system board. If the cable is properly connected, then replace the system board. See “System board removal”. If the CIS module still does not move, then replace the scanner unit. See “Scanner unit removal”.
Display: An error was detected in reading or writing NVRAM.
Description: NVRAM R/W
Remedy: Unplug the printer from the electrical outlet, wait for 10 seconds, and then plug the printer back in. If the problem remains, then replace the printer. Service: Replace the system board.
Remedy: Unplug the printer from the electrical outlet, wait for 10 seconds, and then plug the printer back in. If the problem remains, then replace the printer. Service: Replace the system board.
Display: General hardware failure (unable to localize failure to a specific system).
Description: Hardware failure
Remedy: Unplug the printer from the electrical outlet, wait for 10 seconds, and then plug the printer back in. If the problem remains, then replace the printer. Service: Replace the system board.
Remedy: Unplug the printer from the electrical outlet, wait for 10 seconds, and then plug the printer back in. If the problem remains, then replace the printer. Service: Replace the system board
Display: The DC paper feed system fails to initialize or calibrate.
Description: Paper system failure
Remedy: Unplug the printer from the electrical outlet, wait for 10 seconds, and then plug the printer back in. If the problem remains, then replace the printer. Service: Replace the system board.
Nhận ưu đãi sớm nhất khi chương trình diễn ra
Đăng ký nhận bản tin
Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này.
Chính sách cookie
Những cookie này là cần thiết để trang web hoạt động đúng cách.
Những cookie này giúp chúng tôi hiểu cách khách truy cập tương tác với trang web.
Những cookie này được sử dụng để cung cấp quảng cáo cá nhân hóa.