Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Lexmark S510 — Trang 5/6

Code: 33

Display: Firmware attempted to load or store to an invalid address.
Description: Data abort error
Remedy: Unplug the printer from the electrical outlet, wait for 10 seconds, and then plug the printer back in. If the problem remains, then replace the USB cable. Service: Replace the system board.

Code: 34

Display: Indicates the ARM processor was in an incorrect mode to perform the requested operation.
Description: Invalid processor mode error
Remedy: Unplug the printer from the electrical outlet, wait for 10 seconds, and then plug the printer back in. If the problem remains, then replace the USB cable. Service: Replace the system board.

Code: 35

Display: There is a problem determining temperature.
Description: Temperature error
Remedy: Unplug the printer from the electrical outlet, wait for 10 seconds, and then plug the printer back in. If the problem remains, then replace the printhead. Service: 1. Clean the printhead contacts. If the problem remains, then replace the printhead. 2. Check for bent contacts on the tank contact card. If the contacts are bent, the replace the tank contact card. See “Tank contact card removal”. If the problem remains, then replace the system board.

Code: 36

Display: Invalid parameters have been passed to ReadFlashPage
Description: Serial flash error
Remedy: Unplug the printer from the electrical outlet, wait for 10 seconds, and then plug the printer back in. If the problem remains, then replace the printer. Service: Replace the system board.

Code: 37

Display: Microprocessor has encountered a bad signal (other than an abort, illegal instruction, or arithmetic exception).
Description: Undefined signal error
Remedy: Unplug the printer from the electrical outlet, wait for 10 seconds, and then plug the printer back in. If the problem remains, then replace the USB cable. Service: Replace the system board.

Code: 38

Display: Scanner mechanism is locked in place or unable to move due to other failure
Description: Unlock scanner
Remedy: Unplug the printer from the electrical outlet, wait for 10 seconds, and then plug the printer back in. If the problem remains, then replace the printer. Service: Replace the scanner unit

Code: 39

Display: The scan carrier has stalled.
Description: Scan carrier stall
Remedy: Unplug the printer from the electrical outlet, wait for 10 seconds, and then plug the printer back in. If the problem remains, then replace the printer. Service: Replace the scanner unit.

Code: 40

Display: The microprocessor has encountered an abort or undefined instruction.
Description: Undefined error
Remedy: Unplug the printer from the electrical outlet, wait for 10 seconds, and then plug the printer back in. If the problem remains, then replace the printer. Service: Replace the system board.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie