Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Lexmark X500

Code: 001

Description: Service Call System Board - CPU
Remedy: Replace the RIP board. Or replace the engine controller board.

Code: 002

Description: Service Call System Board - Flash
Remedy: Replace the RIP board. Or replace the engine controller board.

Code: 003

Description: Service Call System Board - DRAM
Remedy: Replace the RIP board. Or replace the engine controller board.

Code: 004

Description: Service Call System Board - RTC
Remedy: Replace the RIP board. Or replace the engine controller board.

Code: 005

Description: Service Call Op Panel
Remedy: 1 Is the operator panel cable properly connected to the op panel? Go to step 2. Properly connect the cable to the op panel. 2 Is the op panel cable properly connected to the RIP board connector J-PNL1? Go to step 3. Properly connect the cable to J-PNL1. 3 Check the op panel cable continuity. Is there continuity? Go to step 4. Replace the flatbed unit. See “Flatbed assembly removal”. 4 Check Voltages on J-PNL1, located on the RIP card. Pin 1 voltage should measure 5V. Is it correct? Replace the operator panel. See “Operator panel removal”. Replace the system board. See “System board removal”.

Code: 006

Description: Service Call Scanner Unit Scanner unit initialization failed. Home position not found. Possible scanner calibration failure.
Remedy: 1 Check to see if the flatbed is locked. Is it locked? Unlock the flatbed. Go to step 2. 2 Ensure that the flatbed motor cable (JFB1) is connected. Is the cable connected? Go to step 3. Properly connect the cable. 3 Check pin 1 in J-FB1 for voltage. The voltage is only present when a copy job is running. The voltage should measure 5V. Is voltage present? Replace the flatbed unit. See “Flatbed assembly removal”. Replace the system board. See “System board removal”.

Code: 007

Description: Service Call Printer Communication Error Print engine fails to initialize.
Remedy: See “Engine controller board removal”.

Code: 008

Description: Service Call Fax Card Fax board fails to initialize or fails to respond when a fax is sent.
Remedy: 1 Is the phone line properly connected to the modem card and the wall jack? Go to step 2. Properly connect the phone line to the modem card and wall jack. 2 Is the modem card cable properly connected to the system board at J-FAX-1 and the modem card? Go to step 3. Properly connect the modem card cable to the modem card and system board. 3 Check the modem card cable for continuity. Is there continuity? Go to step 4. Replace the modem card cable. 4 Check the voltages from connector JFAX1on the RIP card. Check pins 1 and 2 for +3.3V. Pins 24, 27 and 28 are grounds. Are there signals or voltages present? Replace the modem card. See “Modem card removal”. Replace the system board. See “System board removal”.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie