Danh mục sản phẩm

Code :

Code: F4-88
Description: Finisher Gate SENSOR Static JAM (to Stacker Tray) C
Causes: Paper remains on the Gate Sensor when the Finisher is in the Stacker Tray exit mode. At this time, both X'port Entrance Sensor and H-X'port Exit Sensor are OFF state.

Code: H1-1
Description: Tray1 Lift up /No tray fail
Causes: - The TRAY1 LEVEL SENSOR is not turned ON within the specified time after the TRAY1 LEVEL MOTOR is ON. - The TRAY1 SIZE SENSOR detected no tray.

Code: H1-2
Description: Tray2 Lift up /No tray fail
Causes: - The TRAY2 LEVEL SENSOR is not turned ON within the specified time after the TRAY2 FEED MOTOR is ON. - The TRAY2 SIZE SENSOR detected no tray.

Code: H1-3
Description: Tray3 Lift up /No tray fail
Causes: - The 2TM-TRAY3 LEVEL SENSOR is not turned ON within the specified time after the 2TMTRAY3 FEED MOTOR is ON. - The 2TM-TRAY3 SIZE SENSOR detected no tray.

Code: H1-4
Description: Tray4 Lift up /No tray fail
Causes: The 2TM-TRAY4 LEVEL SENSOR is not turned ON within the specified time after the 2TMTRAY4 FEED MOTOR is ON. - The 2TM-TRAY4 SIZE SENSOR detected no tray.

Code: H1-5
Description: HCF Lift Up Fail
Causes: The HCF Level Sensor is not turned ON within the specified time after the HCF Feed Motor is ON.

Code: H2-7
Description: Duplex Module Communication fail
Causes: A communication error occurred between the PWBA MCU F and the Duplex Module.

Code: H2-8
Description: DUP MODULE Type fail
Causes: A DUP MODULE of a different specification is installed.

‹ First < 7 8 9 10 11 12 13 > Last ›

0