Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi OKI C3400 — Trang 6/7

Code: 203 ... 214

Display: Service call 203: Error 204:
Error 207: Error 208: Error 213:
Error 214: Error F0C:
Error FFE: Error FFF: Error
Description: CU program trouble (203~214 are not generated in usual operation)
Remedy: Incorrect processing is performed by the CU program. Does the error recur? Turn on the power supply again. Replace TB3 board.

Code: 209

Display: Service call 209: Down Load Error
Description: Custom Media Type table download failure
Failed in downloarding Custom Media Type Table
Remedy: After the power supply is turned on again, try to download again. (Because this processing is not performed during usual operation, it does not occur.)

Code: 230

Display: Service call 230: Error
Description: RFID Reader not Installed
Remedy: RFID Reader Device error Does the error recur?
Check the connection of the LUM board (RFID reader/writer board). Replace the LUM board (RFID reader/writer board). Replace the TB3 board.

Code: 231

Display: Service call 231: Error
Description: RFID Reader I/F Error
An interface error was detected with the RFID reader device. 01: communication error between the RFID reader and the engine PCB. 02: the transceiver circuit error of the RFID reader. 03: communication error between the RFID reader and the Tag chip. 04: the RFID Tag detection error (more than 4chips).
Remedy: 01: Same as Error 230. 02: Replace the LUM board (RFID reader/writer board). 03: Check the connection of the antenna cable. 04: Check if the number of RFID Tags is correct.

Code: 240

Display: Service call 240: Error
Description: Engine Program Memory Error
240: Flash Memory Hardware Error
Remedy: If the error occurs again after returning on the power supply, replace the board of the unit.

Code: 901, 902

Display: Power off/on 901:Error 902:Error
Description: Short or open in belt thermistor detected.
Remedy: Is belt thermistor cable setting proper? Does error reoccur?
Connect cable set properly again. Turn power ON again. Replace belt thermistor.

Code: 903, 904

Display: Power off/on 903:Error 904:Error
Description: Abnormal temperature detected by belt thermistor (hightemp or low temp.)
Remedy: Is belt thermistor cable setting proper? Does error reoccur?
Connect cable set properly again. Turn power ON again. Replace belt thermistor and leave aside for 30 min. Then turn power ON again.

Code: 923

Display: 923: Error
Description: Image Drum Lock Error
Remedy: The ID motor does not rotate correctly. Is the error message displayed when the power is turned on again?
Check if the ID unit is set correctly. Replace the ID unit. Replace the ID motor.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie