Remedy: Error occurered while writing over the PU firmware. Turn the printer OFF/ ON, and retry to download the PU firmware again. (Usually, the procedure (PU firmware download) which isn’t done, so this is not occur.)
Description: An error was detected of the CU program. (203~214 is not occure in usual operating.)
Remedy: Reinstall the CU board. Is the error message displayed again? After turn power OFF, check connections between CU board and PU board. Then turn power ON again.
Description: Media Table download Error. Downloading Media Table to PU has failure.(Related to Custom Media Type)
Remedy: Downloading Media Table to PU has failure.(Related to Custom Media Type) Turn the printer OFF/ ON, and retry to download the PU firmware, again. (Usually, the procedure isn’t done, so this is not occur.)
Description: Abnormal temperature detected by belt thermistor (high-temp or low temp.)
Remedy: Is belt thermistor cable setting proper? Does error reoccur? Connect cable set properly again. Turn power ON again. Replace belt thermistor and leave aside for 30 min. Then turn power ON again.