Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi OKI C6050 — Trang 3/9

Code: 070

Display: Power off/on 070:Error
Description: PSE firmware fault detected.
Causes: Does error reoccur?

Code: 072

Display: Power off/on 072:Error xx
Description: Engine I/F Error I/F error between PU-CU.
Causes: Is CU assembly set properly? Is error recovered by replacing CU PCB?

Code: 073

Display: Power off/on 073:Error xxxxxxxx
Description: Video Error. A trouble was detected during image data development. (Illegal data received)
Causes: [On the C5650] Is the CU Assy installed properly? Is the error issued again?
[On the C6050/C6150] Is the CU Assy installed properly?
[Common]

Code: 074, 075

Display: Power off/on 074:Error xxxxxxxx 075:Error xxxxxxxx
Description: Video Error Fault detected when image data is extended.
Causes: Is CU assembly set properly?

Code: 081

Display: Service call 081: ERROR
Description: Parameterconsistency check error
Causes: EEPROM or FLASH has become incapable of reading or writing.

Code: 104

Display: Service call 104:Error
Description: Engine EEPROM setting check is OK when power ON. Then detect read/ write error.
Causes: Does error reoccur?

Code: 106

Display: Service call 106:Error
Description: Abnormal engine control logic.
Causes: Does error reoccur?

Code: 111

Display: Service call 111:Error
Description: Detected illegal Duplex Unit.
Causes: Is Duplex Unit of C5300/C5100 installed?
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie