Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi OKI C810 — Trang 8/9

Code: 252, 253

Display: Contact the Service center. 252: Error 253: Error
Description: Disk Security Mode Error
Remedy: Install hard disk that has been connected while introducing the security kit.

Code: 254

Display: Contact the Service center. 254: Error
Description: Disk Security Mode Error
Remedy: Does the error display recur? Turn the power OFF/ON. Regenerate the encrypting mode. If it still does not improve the situation, change the CU board and encrypted hard disk.

Code: 255

Display: Contact the Service center. 255: Error
Description: Disk Security Mode Error
Remedy: Only change the encrypted board.

Code: 256

Display: Contact the Service center. 256: Error
Description: Disk Security Mode Error
Remedy: Install genuine hard disk.

Code: 257

Display: Contact the Service center. 257: Error
Description: Disk Security Mode Error
Remedy: Turn the power OFF/ON. Execute the re-formation of hard disk. If it still does not improve the situation, change the hard disk.

Code: 901 ... 904

Display: Reboot the printer. 901: Error - 904: Error Note)
Description: Abnormal temperature of belt 901: Shortcircuit 902: Open circuit 903: High temperature 904: Low temperature
Remedy: Is the cable from belt thermistor to the high voltage board connected normally? Does this error recur?
Re-connect the cables normally. Turn on the power again. Replace the belt thermistsor.

Code: 918

Display: Reboot the printer. 918: Error
Description: Duplex FAN Alarm Caution
Remedy: Fan error inside the duplex unit. Does the error recur when the power is turned off once and back on? Does the error recur when the power is turned off once and back on?
Check if the Duplex unit is installed normally or not. Check if the fans are installed normally or not. Replace the fan.

Code: 923

Display: Reboot the printer. 923: Error
Description: Black image drum lock error
The K ID does not rotate normally
Remedy: The K ID does not rotate normally. Does the error display recur when the power is turned off once and back on?
Check if the KID is installed normally or not. Replace the K ID unit. Replace the K ID motor.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie