Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi OKI C9000 — Trang 6/9

Code: 160 ... 163

Display: Service Call 160: Error ~ 163: Error
Description: Error detected by Toner sensor.
Remedy: 1) Is the error message displayed? 2) Does the error repeat?
Replace Toner sensor or Assy (Y71-PWB). Same as the above.

Code: 170, 171, 174, 175

Display: Service Call 170: Error 171: Error 174: Error 175: Error
Description: Short or open circuit detected at the Fusert hermistor. (H or L temperature error)
Remedy: 1) Is the error message displayed? 2) Does the error repeat?
Turn off/on the printer. Replace the Thermistor and turn off the printer. Leave it for 30 min.

Code: 172, 176

Display: Service Call 172: Error 176: Error
Description: High temperature error detected at Thermistor
Remedy: 1) Is the error message displayed? 2) Does the error repeat?
Turn off/on the printer. Replace the Thermistor and turn off the printer. Leave it for 30 min.

Code: 173, 177

Display: Service Call 173: Error 177: Error
Description: Low temperature error detected at Thermistor.
Remedy: 1) Is the error message displayed? 2) Does the error repeat?
Turn off/on the printer. Replace the Thermistor or heater and turn off the printer.

Code: 181 ... 186

Display: Service Call 181: Error ~ 186: Error
Description: Communication failure with an option unit detected by Engine
Remedy: 1) Is the error message displayed? 2) Does the error repeat?
Turn off/on the printer. Replace the option unit.

Code: 310

Display: Close Cover 310: CCCC CoverOpen
Description: Printer engine cover is open.
Remedy: 1) Is the Top cover open? 2) Does the Cover switch operatenormally?
Close the Top cover. Close the Side cover. Replace the Cover switch.

Code: 320

Display: Check Fuser 320: Fuser Error
Description: No Fuser unit detected when turning on the printer or closing the cover
Remedy: 1) Is the error message displayed? 2) Is the Fuser unit mounted properly? 3) Does the error repeat?
Confirm the existence of the unit. Re-install the Fuser unit and turn off/on the printer. Replace the Fuser unit Assy.

Code: 330

Display: Check Belt 330: Belt Error
Description: No Belt unit detected when turning on the printer or closing the cover.
Remedy: 1) Is the error message displayed? 2) Is the Belt unit mounted properly? 3) Does the error repeat?
Confirm the existence of the unit. Re-install the Belt unit and turn off/on the printer. Replace the Belt unit Assy.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie